Leader–follower formation control based on non-inertial frames for non–holonomic mobile robots

M. Velasco–Villa,A. Rodriguez–Angeles,I. Z. Maruri–López,J. A. Báez-Hernández,R. D. Cruz Morales
DOI: https://doi.org/10.1371/journal.pone.0297061
IF: 3.7
2024-01-30
PLoS ONE
Abstract:A chain formation strategy based on mobile frames for a set of n differential drive mobile robots is presented. Considering two consecutive robots in the formation, robots R i and R i +1 . It is intended that robot R i +1 follows the delayed trajectory, τ units of time, of the leader robot R i . In this way, the follower robot R i +1 becomes the leader robot for robot R i + 2 in the formation and so on. With this formation policy, the trailing distance between two consecutive robots varies accordingly to the velocity of the R i leader robot. Mobile frames are located on the body of the vehicles, in such a way that the position of robot R i is determined with respect to the frame located on R i +1 robot. The strategy relies on the fact that the general leader robot R 1 describes any trajectory generated by bounded linear v 1 ( t ) and angular ω 1 ( t ) velocities. For the remaining vehicles in the string, the strategy considers a desired trajectory for the follower robot R i +1 obtained by an estimation of the delayed trajectory of the leader robot R i . This desired estimated trajectory is obtained under the knowledge of the actual and past input velocities of the R i robot. To formally prove the convergence of the formation strategy, the equations describing the time variation of the relative posture between any pair of consecutive vehicles in the formation are obtained, and a feedback law based on local measurements is proposed to get the convergence of robot R i +1 to the delayed trajectory, τ units of time, of the trajectory previously described by robot R i . Lyapunov techniques are considered for this fact. The effectiveness of the chain formation solution is evaluated by means of numerical simulations and real time experiments showing an adequate convergence.
multidisciplinary sciences
What problem does this paper attempt to address?