Large adiabatic temperature change and magnetic frustration in triangular lattice antiferromagnet Dy2IrSi3

Sudip Chakraborty,Shuvankar Gupta,Santanu Pakhira,Shovan Dan,Anis Biswas,Yaroslav Mudryk,Chandan Mazumdar
DOI: https://doi.org/10.1016/j.jallcom.2024.173652
IF: 6.2
2024-04-01
Journal of Alloys and Compounds
Abstract:While previous studies reveal that the formation of polycrystalline R2TX3 (R = rare-earth, T = transition metal, X = p-block element) type compounds with T = Ir and Co is not achievable without deliberate introduction of atomic vacancies of Ir/Co and Si, we report successful synthesis of Dy2IrSi3 with fully stoichiometric ratio of constituent elements. An antiferromagnetic transition is manifested in the compound at 6.6 K where only about 50 % of Dy spins take part, while the rest remain in highly frustrated state due to edge-sharing triangular lattice geometry. The magnetic frustration is conclusively probed through magnetization, heat capacity and magnetocaloric study and the frustration parameter (f = ∣θ p ∣/T N, θ p , T N being Curie-Weiss and Néel temperatures, respectively) in this case is as large as ∼ 3. An additional cluster-glass type transition at ∼2.8 K observed in this system has likely been originated due to this magnetic frustration. The magnetocaloric effect reveals an adiabatic temperature change of ∼7.5 K for 70 kOe magnetic field, which is one of the largest values reported in intermetallic compounds.
materials science, multidisciplinary,chemistry, physical,metallurgy & metallurgical engineering
What problem does this paper attempt to address?