Abstract:Next generation cosmic microwave background (CMB) polarimetry experiments aim to deploy order 500,000 detectors, requiring repeatable and reliable fabrication process with stable and uniform transition edge sensor (TES) bolometer performance. We present a hafnium (Hf)-based TES bolometer for CMB experiments. We employ a novel heated sputter deposition of the Hf films enabling us to finely tune the critical temperature (Tc) between 140 mK - 210 mK. We found elevated deposition temperatures result in films with lower stress, larger crystal sizes, and a smaller relative abundance of the m-plane to c-plane $\alpha$ phase, all contributing to the empirical linear dependence of critical temperature on deposition temperature. Crucially, the heated sputter deposition simultaneously ensures that the critical temperature does not drift despite exposure to heat throughout ongoing fab processes (sometimes reaching 350C) as long as the initial deposition temperature is not exceeded. Tcs lower than 170 mK require deposition temperature greater than 400C, far in excess of typical temperatures the wafer may experience. This ample thermal budget allows us to relax the stringent thermal management that conventional aluminum manganese (AlMn) TES bolometers require, for which temperatures as low as 200C - 250C are used to anneal the AlMn in an effort to adjust the Tc. Hf additionally exhibits an intrinsic steep superconducting transition (we measure $\alpha >$ 200) and a corresponding high loop gain (exceeding $\mathcal{L}>10$ deep in the transition). We precisely design the normal resistance of the TES to range between 10 milli-Ohm and 1 Ohm through an interdigitated geometry, making these TES bolometers compatible with both TDM, FDM, and $\mu$-mux readout systems. We report on bolometer parameters including critical temperature, normal resistance, saturation power, time constant, and loop gain.

Commercially fabricated antenna-coupled Transition Edge Sensor bolometer detectors for next generation Cosmic Microwave Background polarimetry experiment

Commercialization of micro-fabrication of antenna-coupled Transition Edge Sensor bolometer detectors for studies of the Cosmic Microwave Background

Silicon-Based Antenna-Coupled Polarization-Sensitive Millimeter-Wave Bolometer Arrays for Cosmic Microwave Background Instruments

Antenna-coupled TES bolometers used in BICEP2, Keck array, and SPIDER

Development of hafnium-based transition edge sensor bolometers for cosmic microwave background polarimetry experiments

Design and characterization of a 90 GHz CMB TES bolometer

A 220 GHz Superconducting Titanium Transition Edge Sensor Array Developed for Cosmic Microwave Background Experiments

Antenna-coupled TES bolometers for the Keck Array, Spider, and Polar-1

Frequency Multiplexed SQUID Readout of Large Bolometer Arrays for Cosmic Microwave Background Measurements

A Dual-polarized Broadband Planar Antenna and Channelizing Filter Bank for Millimeter Wavelengths

Wide-Range Bolometer with RF Readout TES

Hierarchical sinuous-antenna phased array for millimeter wavelengths

The Simons Observatory Microwave SQUID Multiplexing Detector Module Design

Crosstalk Effects in Microwave SQUID Multiplexed TES Bolometer Readout

The Simons Observatory: Production-level Fabrication of the Mid- and Ultra-High-Frequency Wafers

Characterization and Improvement of the Thermal Stability of TES Bolometers

Development of MKIDs for measurement of the Cosmic Microwave Background with the South Pole Telescope

Development of the characterization methods without electrothermal feedback for TES bolometers for CMB measurements

Magnetic Sensitivity of AlMn TESes and Shielding Considerations for Next-Generation CMB Surveys