Broadband Impulsive Stimulated Raman Scattering based on a Chirped Detection

Giovanni Batignani,Carino Ferrante,Giuseppe Fumero,Tullio Scopigno

DOI: https://doi.org/10.1021/acs.jpclett.9b03061

2019-11-27

Abstract:In Impulsive Stimulated Raman Scattering vibrational oscillations, coherently stimulated by a femtosecond Raman pulse, are real time monitored and read out as intensity modulations in the transmission of a temporally delayed probe pulse. Critically, in order to retrieve broadband Raman spectra, a fine sampling of the time delays between the Raman and probe pulses is required, making conventional ISRS ineffective for probing irreversible phenomena and/or weak scatterers typically demanding long acquisition times, with signal to noise ratios that crucially depend on the pulse fluences and overlap stabilities. To overcome such limitations, here we introduce Chirped based Impulsive Stimulated Raman Scattering (CISRS) technique. Specifically, we show how introducing a chirp in the probe pulse can be exploited for recording the Raman information without scanning the Raman-probe pulse delay. Then we experimentally demonstrate with a few examples how to use the introduced scheme to measure Raman spectra.

Chemical Physics

What problem does this paper attempt to address?

This paper aims to address the limitations of the traditional Impulsive Stimulated Raman Scattering (ISRS) technique in broadband Raman spectroscopy measurements. Specifically, the paper points out the following main issues:

1. **Limitations of time - delay scanning**: In order to obtain broadband Raman spectra, traditional ISRS requires fine sampling of the time delay between the Raman pulse and the probe pulse. This results in a long - lasting acquisition process. Especially when studying irreversible phenomena or weak scatterers, the signal - to - noise ratio is severely affected by the pulse energy and overlap stability.

2. **Limited spectral resolution**: Since ISRS can only monitor vibrational coherence within a limited time window, its spectral resolution is limited by the maximum time delay \(T_M\), that is, \(\Delta\tilde{\nu}=\frac{1}{c\cdot T_M}\). In addition, the maximum resolvable frequency (Nyquist frequency) is limited to half of the sampling frequency \(\nu_{\text{Sam}} = \frac{1}{\Delta T}\), so accessing high - frequency Raman modes usually requires a long acquisition time.

3. **Low signal - to - noise ratio**: During time - delay scanning, laser fluctuations can cause the signal - to - noise ratio to be lower than that of frequency - domain Raman spectroscopy techniques. Especially in the case of low - cross - section or low - concentration compounds, these fluctuations may mask ISRS oscillations.

4. **Limitations of multiple shots**: ISRS requires multiple shots to acquire data, which makes this technique inapplicable to the study of irreversible processes, such as phase transitions or non - reversible chemical reactions, as well as phenomena accompanied by sample damage.

To solve these problems, the paper introduces a Chirped - based Impulsive Stimulated Raman Scattering (CISRS) technique. By introducing a chirp in the probe pulse, Raman information can be recorded without scanning the time delay between the Raman pulse and the probe pulse. This method not only significantly improves the data acquisition speed but also improves the signal - to - noise ratio, and is suitable for rapid measurement of broadband Raman spectra.