Abstract:The passage of time is tracked by counting oscillations of a frequency reference, such as Earth’s revolutions or swings of a pendulum. By referencing atomic transitions, frequency (and thus time) can be measured more precisely than any other physical quantity, with the current generation of optical atomic clocks reporting fractional performance below the 10−17 level1–5. However, the theory of relativity prescribes that the passage of time is not absolute, but is affected by an observer’s reference frame. Consequently, clock measurements exhibit sensitivity to relative velocity, acceleration and gravity potential. Here we demonstrate local optical clock measurements that surpass the current ability to account for the gravitational distortion of space-time across the surface of Earth. In two independent ytterbium optical lattice clocks, we demonstrate unprecedented values of three fundamental benchmarks of clock performance. In units of the clock frequency, we report systematic uncertainty of 1.4 × 10−18, measurement instability of 3.2 × 10−19 and reproducibility characterized by ten blinded frequency comparisons, yielding a frequency difference of [−7 ± (5)stat ± (8)sys] × 10−19, where ‘stat’ and ‘sys’ indicate statistical and systematic uncertainty, respectively. Although sensitivity to differences in gravity potential could degrade the performance of the clocks as terrestrial standards of time, this same sensitivity can be used as a very sensitive probe of geopotential5–9. Near the surface of Earth, clock comparisons at the 1 × 10−18 level provide a resolution of one centimetre along the direction of gravity, so the performance of these clocks should enable geodesy beyond the state-of-the-art level. These optical clocks could further be used to explore geophysical phenomena10, detect gravitational waves11, test general relativity12 and search for dark matter13–17.

The unit of time: present and future directions

Towards a Re-definition of the Second Based on Optical Atomic Clocks

Atomic clock performance beyond the geodetic limit

Atomic clock performance enabling geodesy below the centimetre level

Remote atomic clock synchronization via satellites and optical fibers

On a definition of the SI second with a set of optical clock transitions

Direct Demonstration of Spin-Squeezing-induced Metrological Enhancement on State-of-the-art Optical Atomic Clocks

Atomic clocks for geodesy

Atomic clocks: new prospects in metrology and geodesy

Realization of a time-scale with an accurate optical lattice clock

Precision Measurement and Frequency Metrology with Ultracold Atoms

Time scales in the context of general relativity

Towards Adoption of an Optical Second: Verifying Optical Clocks at the SI Limit

Editorial: Quantum Precision Measurement and Cold Atom Physics

Frequency Ratio Measurements with 18-digit Accuracy Using a Network of Optical Clocks

Colloquium: Physics of optical lattice clocks

Advances in Atomic Time Scale imaging with a Fine Intrinsic Spatial Resolution

A quantum network of clocks

Systematic evaluation of an atomic clock at 2e-18 total uncertainty

Optical Frequency Transfer on the Order of 10−19 Fractional Frequency Instability over a 64 m Free-Space Link

Past, present and future of atomic clocks for GNSS