Abstract:In this article, a laboratory sample of an energy transmission system over a fiber-optic communication line is being developed and investigated, which makes it possible to provide power to autonomous ultra-low-power electronic devices located at a considerable distance from energy sources. The system being developed will make it possible to abandon the use of copper conductors and batteries for autonomous stationary devices, which is associated with certain difficulties from the point of view of technical implementation. The result of this study is a developed laboratory sample that allows measuring the values of current and voltage in the branch of the photodetector. The method of an equivalent generator was used, as well as the well-known laws of a circuit with two dedicated nodes for an active two- pole. When analyzing the literature, scientific achievements and discoveries in the field of research, a proprietary research concept was formulated that differs from foreign analogues. During the experiment, the photodetector was in idle, short-circuit mode and was connected to a high-resistance load. Based on experimental data, volt-ampere characteristics (VAC) were constructed using a radiation source (laser) with a power of 10 and 30 MW. The technical parameters and characteristics of the radiation source and the irradiated silicon crystal are given. The output electrical power is determined using the laws of electrical engineering, including Ohm's law. To process the results obtained, quadratic interpolation of the function, the results of the root-mean-square approximation were used, and regression analysis was also performed. Absolute and relative errors were calculated. The student's coefficient was determined with a confidence interval of 0.95. According to the results of the study, the efficiency of a laboratory sample of an energy transmission system over a fiber-optic communication line was determined.

A Fiber Optic Based High Voltage System for Stellar Intensity Interferometry Observations

A Novel ZVS High Voltage Power Supply for Micro-Channel Plate Photomultiplier Tubes

Stellar Intensity Interferometric Capabilities of IACT Arrays

Validation of high voltage power supplies for the 1-inch photomultipliers of AugerPrime, the Pierre Auger Observatory upgrade

Astrophysical measurements with the VERITAS Stellar Intensity Interferometer

Coherently combined master oscillator fiber power amplifiers for Advanced Virgo

Optical design study of an infrared visible viewing system for Wendelstein 7-X divertor observation and control

Design, Performance, and Application of a Line-Imaging VISAR Coupled with SOP System at the Shenguang-II Upgrade Laser Facility

The Fibre Resolved opticAl and Near-ultraviolet Czerny-Turner Imaging Spectropolarimeter (FRANCIS)

A Fiber-Optic Analog Isolator of Up to 10 MHz Bandwidth

A compact actively damped vibration isolation platform for optical experiments in ultra-high vacuum

Compact Vibration Isolation and Suspension for Australian International Gravitational Observatory: Performance in a 72 M Fabry Perot Cavity.

Digital Transformation of High Voltage Isolation Control and Monitoring System for HVE-400 Ion Implanter

Design considerations for an ultrahigh-bandwidth Phase 6 Contrast Imaging system applied to fusion grade devices

Increased accuracy and signal-to-noise ratio through recent improvements in Infra-Red Video Bolometer fabrication and calibration

Optical fiber-based power and data delivery system for high voltage electronic current transformer

DEVELOPMENT AND RESEARCH OF A LABORATORY SAMPLE OF AN ENERGY TRANSMISSION SYSTEM BASED ON A FIBER-OPTIC COMMUNICATION LINE

Experimental Demonstration of Broadband Generation of Optical Vortices Using Asymmetrically Spliced Fibers

Highlight Talk: Recent Results from VERITAS

Science Highlights from VERITAS

Characterization and Novel Application of Power Over Fiber for Electronics in a Harsh Environment