Linear Stability Analysis of a Normal Shock Train in a Constant Area Isolator of a Hypersonic ScramJet

Swetava Ganguli
DOI: https://doi.org/10.48550/arXiv.1907.08568
2019-07-31
Abstract:Recent experiments in hypersonic vehicle technology have had some successful outcomes (ex. NASA X-43, Boeing X-51) but also have seen some unexpected failures (DARPA Hypersonic Test Vehicle 2). One important failure mode is the problem of engine unstart. Morgan, et al (2012) has discussed and analyzed a Scramjet isolator using two unit problems, viz. that of an oblique shock impinging on a turbulent boundary layer and that of a normal shock train in a constant-area duct. In order to analyze unstart, we use the numerical data obtained from the LES calculations of the normal shock train in a constant area duct and perform temporal linear stability analysis on it under the assumptions of inviscid semi-parallel flow. This paper describes the methodology and the details of this linear stability analysis. The results obtained from the investigations have been documented and interpreted with their relevance to the physical problem. The report concludes that temporal linear stability analysis is insufficient to analyze the problem of unstart. Finally, the need for a new approach (namely, dynamic mode decomposition (DMD)) has been discussed.
Fluid Dynamics,Analysis of PDEs
What problem does this paper attempt to address?
The problem that this paper attempts to solve is the linear stability analysis of the normal shock train in the isolator of a scramjet. Specifically, the research objective is to conduct a time - linear stability analysis of the normal shock train in the isolator with a constant cross - section by using data obtained from large - eddy simulation (LES) calculations, in order to understand whether the instabilities of these shock trains will lead to engine unstart. Engine unstart refers to the phenomenon that the shock system in the isolator is expelled from the air inlet, which is an important failure mode in hypersonic vehicle technology. The paper explores the nature of these instabilities by numerical methods and evaluates their relevance to the physical problem. Finally, the paper concludes that time - linear stability analysis alone is not sufficient to fully analyze the unstart problem, and proposes that new methods, such as dynamic mode decomposition (DMD), need to be adopted for further research.