Abstract:Minimally invasive experimental methods that can measure local rate dependent mechanical properties are essential in understanding the behaviour of soft and biological materials in a wide range of applications. Needle based measurement techniques such as Cavitation Rheology and Volume Controlled Cavity Expansion (VCCE), allow for minimally invasive local mechanical testing, but have been limited to measuring the elastic material properties. Here, we propose several enhancements to the VCCE technique to adapt it for characterization of viscoelastic response at low to medium stretch rates ($10^{-2}$ - $1$ s${}^{-1}$). The proposed technique performs several cycles of expansion-relaxation at controlled stretch rates in a cavity expansion setting and then employs a large deformation viscoelastic model to capture the measured material response. Application of the technique to soft PDMS rubber reveals significant rate dependent material response with high precision and repeatability, while isolating equilibrated states that are used to directly infer the quasistatic elastic modulus. The technique is further established by demonstrating its ability to capture changes in the rate dependent material response of a tuneable PDMS system. The measured viscoelastic properties are used to explain earlier reports of rate insensitive material response by needle based methods: it is demonstrated that the conventional use of constant volumetric rate cavity expansion can induce high stretch rates that lead to viscoelastic stiffening and an illusion of rate insensitive material response. We thus conclude with a cautionary note on possible overestimation of the quasistatic elastic modulus in previous studies and suggest that the stretch rate controlled expansion protocol, proposed in this work, is essential for accurate estimation of both quasistatic and dynamic material parameters.

Capturing Strain Stiffening Using Volume Controlled Cavity Expansion

Evolving properties of biological materials captured via needle-based cavity expansion method

Probing local nonlinear viscoelastic properties in soft materials

Cylindrical Cavity Expansion: A Novel Method for Characterizing the Mechanical Properties of Soft Materials

Non-destructive mapping of stress, strain and stiffness of thin elastically deformed materials

Strain stiffening universality in composite hydrogels and soft tissues

An Open-Source Membrane Stretcher for Simultaneous Mechanical and Structural Characterizations of Soft Materials and Biological Tissues

An Accessible Instrument for Measuring Soft Material Mechanical Properties

Noninvasive Measurement of Local Stress Inside Soft Materials with Programmed Shear Waves

3D Strain and Elasticity Measurement of Layered Biomaterials by Optical Coherence Elastography Based on Digital Volume Correlation and Virtual Fields Method

Non-destructive mapping of stress and strain in soft thin films through sound waves

Observation of dynamic strain hardening in polymer nanocomposites.

A Non-invasive Method to Estimate the Stress-Strain Curve of Soft Tissue Using Ultrasound Elastography

Cavity expansion in nonlinear viscoelastic solids: A nonlinear dynamic study

Analytical Modeling and Implementation of an Imaging Cantilever With a Thermoplastic Stiffener

Development of Improved Confined Compression Testing Setups for Use in Stress Relaxation Testing of Viscoelastic Biomaterials

Nondestructively Identifying the Mechanical Behavior of Soft Tissues Using Surface Deformation with an Explicit Inverse Approach

Direct, Model-Free Acoustic Evaluation of Stresses and Strains in Loaded Nonlinear Soft Solids

Power-law Modeling for Swift Viscoelastic Assessment in Biological Soft Tissues

Elastic Stiffness Characterization Using Three-Dimensional Full-Field Deformation Obtained with Optical Coherence Tomography and Digital Volume Correlation

Immersed Cantilever Apparatus for Mechanics and Microscopy