Abstract:In this dissertation, the relationships between structure-mechanical properties-deformation mechanisms in face-centered cubic (FCC) and body-centered cubic (BCC) metallic nanowires have been studied using in situ TEM nanomechanical testing. It is well known that smaller is stronger and the widely-observed size effect is believed to arise from dislocation interactions inside nanocrystals. However, the interaction mechanisms in small-volume nanocrystals remain unexplored. Here, it was found that surface-nucleated dislocations can strongly interact inside the confined volume of Au nanowires, which led to a new type of dislocation-originated stacking fault tetrahedra (SFT), at variance to the widely-believed vacancy-originated SFT. The atomic-scale processes of nucleation, migration and annihilation of dislocation-originated SFT were revealed, shedding new light onto the strain hardening and size effect in small-volume materials. Although nanoscale twinning is an effective mean to enhance the strength of metals, twin-size effect on the deformation and failure of nanotwinned metals remains largely unexplored, especially at the minimum twin size. Here, a new type of size effect in nanotwinned Au nanowires is presented. As twin size reaches the angstrom-scale, Au nanowires exhibit a remarkable ductile-to-brittle transition that is governed by the heterogeneous-to-homogeneous dislocation nucleation transition. Quantitative measurements show that approaching such a nanotwin size limit gives rise to the ultra-high strength in Au nanowires, close to the ideal strength limit of perfect Au. Twinning is a fundamental deformation mode that competes against dislocation slip in crystals. At the nanoscale, higher stresses are required for plastic deformation than that in bulk, which favors twinning over dislocation slip. Indeed, deformation twinning has been well-documented in FCC nanocrystals. However, it remains unexplored in BCC nanostructures. Here, it shows that twinning is the dominant deformation mode in BCC-tungsten nanocrystals. A competition between twinning and dislocation slip occurs when changing the loading orientations, attributed to the defect growth controlled plasticity in BCC nanocrystals. Several important commonalities and differences in FCC and BCC nanocrystals deforming at nanoscale are further proposed. The results from this dissertation advance fundamental understanding of plastic deformation in a broad class of metals and alloys, and are of technological importance for degradation control and future design of ultra-strength nanomaterials.

The $Λ$-invariant and topological pathways to influence sub-micron strength and crystal plasticity

Size-Dependent Dislocation-Twin Interactions

In Situ TEM Study on the Nanomechanical Behaviors of Metallic Nanowires

New Mechanisms of Helical Dislocation Formation Via the Pinch-off Process Near a Nano-Inhomogeneity

Fluctuations in crystalline plasticity

On identifying dynamic length scales in crystal plasticity

Spatio-temporal plastic instabilities at the nano/micro scale

Enhanced mobility of dislocation network nodes and its effect on dislocation multiplication and strain hardening

Probing microplasticity in small scale FCC crystals via Dynamic Mechanical Analysis

Dislocation breakaway from nanoparticle array linear complexions: Plasticity mechanisms and strength scaling laws

Dynamic Length Scale and Weakest Link Behavior in Crystal Plasticity

Effects of Rate, Size and Prior Deformation in Microcrystal Plasticity

Dislocation reactions, grain boundaries, and irreversibility in two-dimensional lattices using topological tweezers

Size dependence of dislocation-mediated plasticity in Ni single crystals: molecular dynamics simulations

Elastodynamics Field of Non-Uniformly Moving Dislocation: from 3D to 2D

Elastic Interaction-Induced Anisotropic Growth of Dislocation Loop Arrays

High-Resolution Methods for Characterizing Mesoscale Dislocation Structures

Size dependent scaling law of plastic flow in FCC Nanolattices: A Dislocation Dynamics Study

A Geometric Field Theory of Dislocation Mechanics

Microstructural inelastic fingerprints and data-rich predictions of plasticity and damage in solids

Nonlocal Machine Learning of Micro-Structural Defect Evolutions in Crystalline Materials