Abstract:A significant challenge in utilizing hydrogen in conventional internal combustion engines is achieving a balance between NOx emissions and brake power output. A lean premixed charge (Lambda ≈ 2.5) allows for efficient and stable combustion with minimal NOx emissions. However, this comes at the cost of reduced power density due to the higher air requirements of the thermodynamic process. While supercharging can mitigate this drawback, it introduces increased complexity, cost, and size. An intriguing alternative is the 2-stroke cycle, particularly in an opposed piston (OP) configuration. This study presents the virtual development of a single-cylinder 2-stroke OP engine with a total displacement of 0.95 L, designed to deliver 25 kW at 3000 rpm. Thanks to its compact size, high thermal efficiency, robustness, modularity, and low manufacturing cost, this engine is intended for use either as an industrial power unit or in combination with electric motors in hybrid vehicles. The overarching goal of this project is to demonstrate that internal combustion engines can offer a practical and cost-effective alternative to hydrogen fuel cells without significant penalties in terms of efficiency and pollutant emissions. The design of this novel engine started from scratch, and both 1D and 3D CFD simulations were employed, with particular focus on optimizing the cylinder's geometry and developing an efficient low-pressure injection system. The numerical methodology was based on state-of-the-art commercial codes, in line with established engineering practices. The numerical results indicated that the optimized engine configuration slightly surpasses the target performance, achieving 29 kW at 3000 rpm, while maintaining near-zero NOx emissions (<20 ppm) and high brake thermal efficiency (~40%) over a wide power range. Additionally, the cost of this engine is projected to be lower than an equivalent 4-stroke engine, due to fewer components (e.g., no cylinder head, poppet valves, or camshafts) and a lighter construction.

Proposal of a realistic stochastic rotor engine based on electron shuttling

Autonomous Rotor Heat Engine

Mechanical Autonomous Stochastic Heat Engine.

Working Mechanism and Characteristics of Gas Parcels in the Stirling Cycle

Development and Experimental Investigation of a Two-Stroke Opposed-Piston Free-Piston Engine

A Third-Order Numerical Model and Transient Characterization of a Β-Type Stirling Engine

Realization of all-optical underdamped stochastic Stirling engine

An all-optical nanomechanical heat engine

Realization of an All-Optical Underdamped Stochastic Stirling Engine

Stochastic Heat Engine Using Multiple Interacting Active Particles

Investigation of a single-phase oscillating PM alternator for free-piston stirling engines

Experiments on nonlinear dynamics and thermodynamics of autonomous heat engine

Stochastic Thermodynamic Cycles of a Mesoscopic Thermoelectric Engine

Maximum power Stirling-like heat engine with a harmonically confined Brownian particle

Study of quantum Otto heat engine using driven-dissipative Schrödinger equation

Autonomous quantum heat engine based on non-Markovian dynamics of an optomechanical Hamiltonian

Virtual Development of a Single-Cylinder Hydrogen Opposed Piston Engine

A general stability analysis method for regenerative oscillating heat engines based on heat-dynamics network model and Nyquist criterion

Experimental characterization of autonomous heat engine based on minimal dynamical-system model

Alternative Low Temperature Stirling Engine Based Source of Energy for Autonomous Consumers