Abstract:A broad consensus of neutralizing the carbon dioxide emissions facilitates the transition to the renewable energy power system. Meanwhile, the concerns about the volatility of renewable energies are growing as the rotational inertia of power system becomes inadequate. To maintain the frequency stability of power system, some studies for configuring inertia energy storage systems (ESSs) are carried out, mainly focusing on the allocation of virtual inertia from grid-forming ESS. In contrast, the allocation of virtual inertia from grid-following ESS has not been well elaborated and the differences in virtual inertia provided by these two modes are yet to be revealed. Based on H2$\mathcal {H}_2$-norm and Kron reduction, firstly, the state-space model of post-disturbance system is established, together with the transient performance evaluation. Then the inertia characteristics of both grid-forming and grid-following devices are formulated, followed by the unified gradient descent optimization method for allocating virtual inertia. A modified IEEE 39-bus system and its time-domain simulations help in the verification of the contribution of this paper. Through the comparative analysis of corresponding optimal results, the conclusions from two aspects are drawn: in terms of transient frequency support, the grid-forming devices can provide no less than 26%$26\%$ better inertia support; with the higher power capacity and similar energy capacity, the grid-forming devices can relieve the response pressure of other generators by approximately 77.1%$77.1\%$. The inertia modelling of both grid-forming and grid-following devices is established for a more accurate configuration of inertia. A unified gradient descent optimization method for allocating virtual inertia is proposed. The differences between virtual inertia provided by grid-forming and grid-following devices are analysed. image

Controlling Time-Variant Virtual Inertia from Storage by Dynamic Programming and PROPT

Controlling Power and Virtual Inertia from Storage for Frequency Response

Optimal Allocation of Energy Storages: A Perspective of System Inertia Support

An Adaptive Inertia Control to Improve Stability of Virtual Synchronous Machines under Various Power Grid Strength

Virtual Inertia Control and Multi-time Scale Control Parameter Design of CHB-BESS

Rotor Inertia Adaptive Control and Inertia Matching Strategy Based on Parallel Virtual Synchronous Generators System

Analysis of Inertia Mechanism of Grid-tied Photovoltaic Power Generation System with Virtual Inertia Control

Resilent Active Power and Virtual Inertia Coordinated Control for Multiple Distributed Energy Storage Units

Comparative Analysis and Optimal Allocation of Virtual Inertia from Grid‐forming and Grid‐following Controlled ESSs

Research on design and simulation experiment of virtual inertia controller for doubly fed induction generator

Distributed Frequency Control in Power Grids with Low and Time-Varying Inertia

Enhancing Frequency Emergency Control with Battery Energy Storage Systems in Low-Inertia Power Grid

Effective virtual inertia control using inverter optimization method in renewable energy generation

Online Event-Triggered Switching for Frequency Control in Power Grids with Variable Inertia

Cooperative adaptive inertial control for PV and energy storage units with multiple constraints

Optimal Allocation of Virtual Inertia Devices for Enhancing Frequency Stability in Low-Inertia PowerSystems

Virtual Inertia Optimization for Microgrids with High Renewable Penetration Considering Frequency Stability Constraints

Virtual Inertia Emulation in Islanded Microgrids with Energy Storage System

Multi-Timescale Control of Variable-Speed Wind Turbine for Inertia Provision

Optimal Battery Storage Configuration for High-Proportion Renewable Power Systems Considering Minimum Inertia Requirements

Frequency Stability Enhancement of Microgrid Using Optimization Techniques-Based Adaptive Virtual Inertia Control