Abstract:Abstract In this study, the inharmonicity of bass guitar strings with and without areas of lowered and raised mass near the saddle is studied. Using a very high sample rate of over 900 kHz enabled finite difference time domain simulation to be applied for strings that simultaneously have nonzero stiffness and linear density which varies along the length of the string. Results are compared to experiments on specially constructed strings. Perturbation theory is demonstrated to be sufficiently accurate (and much more computationally efficient) for practical design purposes in reducing inharmonicity. The subject of inharmonicity is well known in pianos but has not been studied extensively in bass guitar strings. Here, the inharmonicity is found to be low in the lowest (open string) pitch on the five string bass guitar ( $${B}_0$$ B 0 ) given typical standard construction. Conversely, the inharmonicity is high (around 100 cents at the 10th partial) when that string is sounded when stopped at the 12th fret and very high (around 100 cents at the 6th partial) when that string is stopped at the 21st fret. Bass guitar strings were constructed with three different constructions (standard, tapered and lumped) in order to demonstrate how incorporating a lump of raised mass near the saddle can achieve close to zero inharmonicity for the lower frequency partials. This also has potential in terms of improving the use of higher fret numbers for musical harmony (reducing beating) and also in controlling pitch glide that has, with some exceptions, often been attributed solely to nonlinear behaviour.

Banjo Ring from Stretching String: A Zero Break Angle Demo

Banjo Break Angle Tension Modulation as Parametric Oscillation

Arithmetic of Spring Forces on the Banjo Bridge

Whither Tone Ring Ring?

The acoustical behavior of a bass guitar bridge with no saddles

Comparison of the Dynamic Performance of Nonlinear One and Two Degree-Of-Freedom Vibration Isolators with Quasi-Zero Stiffness

Vibrations of a Violin While the f-Holes were Sequentially Cut

On inharmonicity in bass guitar strings with application to tapered and lumped constructions

Banjo Transformations and Bluegrass Rhythm

Effect of indented growth rings on spruce wood mechanical properties and subsequent violin dynamics

Static analysis of violin bow behavior under playing loads

Vibro-acoustics time domain FEM-BEM analysis of a Titian Stradivari violin: the role of the bridge

A necessary condition for double-decay envelopes in stringed instruments

Parametric Experimental Modal Analysis of a Modern Violin Based on a Guarneri del Gesù Model

Perceptual evaluation of bracewood and soundboard wood variations on the preference of a steel-string acoustic guitar

Influence of the player on the dynamics of the electric guitar

Dynamic analysis on Guzheng string vibration and bridge transmission

Bridge shapes of the violin and other bowed instruments, 1400–1900: the origin and evolution of their design

Preservation of the harmonic overtones in the violin family beyond Stradivari

Tone‐Quality of Bowed‐String Instruments and Its Variation by Violin‐Making

Inharmonicity in plucked guitar strings