Abstract:Background: Liquid droplets can be spontaneously charged in the absence of applied electric fields by spraying. It has been shown by computational simulation that charges may influence particle deposition in the airways. The electrostatic properties of jet nebulized aerosols and their potential effects on lung deposition have hardly been studied. A modified electrical low pressure impactor (ELPI) was employed to characterize the aerosol charges generated from jet nebulized commercial products. Methods: The charge and size measurements were conducted at 50% RH and 22 degrees C with a modified ELPI. Ventolin, Bricanyl, and Atrovent were nebulized using PARI LC Plus jet nebulizers coupled to a DeVilbiss Pulmo-Aide compressor. The aerosols were sampled in 30-sec durations. The drug deposits on the impactor stages were assayed chemically using high-performance liquid chromatography (HPLC). The charges of nebulized deionized water, isotonic saline, and the three commercial products diluted with saline were also measured to analyze the contributions of the major nebule ingredients on charging. No mass assays were performed on these runs. Results: All three commercial nebules generated net negative charges. The magnitude of the charges reduced over the period of nebulization. Ventolin and Bricanyl yielded similar charge profiles. Highly variable charges were produced from deionized water. On the other hand, nebulized saline reproducibly generated net positive charges. Diluted commercial nebules showed charge polarity inversion. The charge profiles of diluted salbutamol and terbutaline solutions resembled those of saline, while the charges from diluted ipratropium solutions fluctuated near neutrality. Conclusions: The charge profiles were shown to be influenced by the concentration and physicochemical properties of the drugs, as well as the history of nebulization. The drugs may have unique isoelectric concentrations in saline at which the nebulized droplets would carry near-zero charges. According to results from computational simulation models in the literature, the numbers of elementary charges per droplet estimated from the data were not high enough to potentially affect lung deposition.

Introduction of the electrical next generation impactor (eNGI) and investigation of its capabilities for the study of pressurized metered dose inhalers

Aerosol deposition and emission from a United States Pharmacopeia‐induction port when using a pressurized metered‐dose inhaler with and without a valved holding chamber

In Vitro Analysis of Aerodynamic Properties and Co-Deposition of a Fixed-Dose Combination of Fluticasone Furoate, Umeclidinium Bromide, and Vilanterol Trifenatate

Comparison of the Particle Size Distribution and Vapor Phase of Electronic Nicotine Delivery Systems Using Two Impactors

Aerodynamic particle size distribution and dynamic properties in aerosols from electronic cigarettes

Revealing pMDI Spray Initial Conditions: Flashing, Atomisation and the Effect of Ethanol

In-vitro and Particle Image Velocimetry Studies of Dry Powder Inhalers

Acceptance Testing of Used Cascade Impactor Stages Based on Pressure Drop Measurements in a Flow System Managed with a Critical Flow Venturi: Part I-Laboratory Proof-of-Principle

In vitro evaluation of solution-based pressurised metered dose inhaler sprays with low GWP propellants

Effect of USP Induction Ports, Glass Sampling Apparatus, and Inhaler Device Resistance on Aerodynamic Patterns of Fluticasone Propionate–Loaded Engineered Mannitol Microparticles

Bioequivalence of Two Tiotropium Dry Powder Inhalers and the Utility of Realistic Impactor Testing

In Vitro Analysis of Nasal Interface Options for High-Efficiency Aerosol Administration to Preterm Infants

Understanding the performance of pressurized metered dose inhalers formulated with low Global warming potential propellants

Performance of different nebulizers in clinical use for Pressurized Intraperitoneal Aerosol Chemotherapy (PIPAC)

Investigating the Accuracy of the Digihaler, a New Electronic Multidose Dry-Powder Inhaler, in Measuring Inhalation Parameters

Optimizing Aerosolization Using Computational Fluid Dynamics in a Pediatric Air-Jet Dry Powder Inhaler

Electrostatic charge characteristics of jet nebulized aerosols

Aerosol size distribution measurement of electronic cigarette emissions using combined differential mobility and inertial impaction methods: Smoking machine and puff topography influence

Effect of Device Design on the Aerosolization of a Carrier-Based Dry Powder Inhaler—a Case Study on Aerolizer ® Foradile ®

The Study of Spray-Freeze-Drying Technique for Development of Novel Combination pMDIs, Part I: Study on the Preparation Method

Characterization of Pediatric Extrathoracic Aerosol Deposition with Air-Jet Dry Powder Inhalers