Abstract:In order to study the dynamic characteristics of micro-organisms or engineered swimmers, the simulations of the motion and interaction of a pair of squirmers in a shear flow are conducted using the lattice Boltzmann method (LBM) in the range of squirmer-type factor -5 <= b <= 5, self-propulsion strength 0.1 <= alpha <= 0.8, initial spacing between two squirmers 0.5d <= d' <= 3d (d is the diameter of the squirmers). The interactions and motion mechanisms of squirmers in puller-puller, pusher-pusher, puller-pusher, and pusher-puller configurations are analyzed. The results show that there are three typical motion patterns in the puller-puller configuration, i.e., steady tilting motion (STM), large-amplitude oscillation motion (LAO), and small-amplitude oscillation motion (SAO). The motion of pullers has a large vertical range, and the swimming angle continues to increase in the LAO, while the pullers oscillate near the plate and have a small range of changes in swimming angles in the SAO. The situation is more complex in the pusher-pusher configuration, and there are five motion patterns, i.e., STM, LAO, SAO, limit cycle motion (LCM), and open limit cycle motion (OLCM). Three different STMs are found according to the pressure distribution around the pushers. d' is an important parameter affecting the interaction of squirmers. In the puller-puller configuration, the backflow area on the right side of puller 1 is completely suppressed when d' = 0.5d, but this suppression gradually weakens as d' increases. Changes in d' result in the differences in the final motion patterns of pullers on the upper and low plates. In the pusher-pusher configuration, changes in d' result in transitions between different motion patterns. There exist a critical swimming angle theta(c) when d' changes, and the pattern changes from the STM to the LCM when theta > theta(c). At d' = 0.5d, in the puller-pusher configuration, there exists a stable structure formed by the mutual repulsion caused by the high pressure area between the puller and pusher. In the pusher-puller configuration, there is a low-pressure area on one side of the pusher, which attracts the low-pressure area on the head of the puller and affects their subsequent motion patterns.

Stability of arrays of bottom-heavy spherical squirmers

Two-dimensional Study on the Motion and Interactions of Squirmers under Gravity in a Vertical Channel

Study on the Interaction and Motion Patterns of Squirmers Swimming in a Shear Flow

Collective behavior of squirmers in thin films

Collective Motions of Microorganisms in Geometric Confinement

Pairwise scattering and bound states of spherical microorganisms

Collective behavior of strongly confined suspensions of squirmers

Swimming Mode of Two Interacting Squirmers under Gravity in a Narrow Vertical Channel.

Motion characteristics of squirmers in linear shear flow

Shape-induced pairing of spheroidal squirmers

Numerical Study of Collective Motion of Microswimmers in Giesekus Viscoelastic Fluids

Swimming of an Inertial Squirmer Array in a Newtonian Fluid

Swimming Velocity of Spherical Squirmers in a Square Tube at Finite Fluid Inertia

Generalized squirming motion of a sphere

Hydrodynamics of an Inertial Squirmer and Squirmer Dumbbell in a Tube

Study of Sedimentation Characteristics of an Elliptical Squirmer in a Vertical Channel

Dynamics of squirmers in explicitly modeled polymeric fluids

Modeling a Spheroidal Squirmer Through a Complex Fluid

Study on the Sedimentation and Interaction of Two Squirmers in a Vertical Channel

Migration and Rheotaxis of Elliptical Squirmers in a Poiseuille Flow

Locomotion of Active Matter over a Circular Cylinder in a Microchannel