Abstract:The present study investigates the impact of micro-EDM based texturing techniques where various patterns are fabricated on the rake faces of turning inserts with and without adding WS 2 nanoparticles in the dielectric medium. It was observed from experimental analysis that the nanoparticle-assisted groove textured tools recorded the highest reduction in average flank wear widths, tool chip contact lengths, and surface roughness values by (40–59%), (11–19%) and (34–46%) respectively while machining Ti6Al4V under dry lubrication conditions. At the same time, WS 2 -assisted dimple textured tools recorded the maximum decrease in chip curl diameter values by (38–55%) compared to the non-textured tools.

Wear characteristics of WS 2 nanoparticle-assisted micro-EDM textured carbide inserts during machining of Ti6Al4V