Abstract:Since 1990, many groups of pressure–volume–temperature (PVT) data from experiments and molecular dynamics (MD) or Monte Carlo (MC) simulations have been reported for supercritical and subcritical water. In this work, fifteen groups of PVT data (253.15–4356 K and 0–90.5 GPa) are evaluated in detail with the aid of the highly accurate IAPWS-95 formulation. The evaluation gives the following results: (1) Six datasets are found to be of good accuracy. They include the simulated results based on SPCE potential above 100 MPa and those derived from sound velocity measurements, but the simulated results below 100 MPa have large uncertainties. (2) The data from measurements with a piston cylinder apparatus and simulations with an exp-6 potential contain large uncertainties and systematic deviations. (3) The other seven datasets show obvious systematic deviations. They include those from experiments with synthesized fluid inclusion techniques (three groups), measured velocities of sound (one group), and automated high-pressure dilatometer (one group) and simulations with TIP4P potential (two groups), where the simulated data based on TIP4P potential below 200 MPa have large uncertainties. (4) The simulated data but those below 1 GPa agree with each other within 2–3%, and mostly within 2%. The data from fluid inclusions show similar systematic deviations, which are less than 2–5%. The data obtained with automated high-pressure dilatometer and those derived from sound velocity measurements agree with each other within 0.3–0.6% in most cases, except for those above 10 GPa. In principle, the systematic deviations mentioned above, except for those of the simulated data below 1 GPa, can be largely eliminated or significantly reduced by appropriate corrections, and then the accuracy of the relevant data can be improved significantly. These are very important for the improvement of experiments or simulations and the refinement and correct use of the PVT data in developing thermodynamic models of water or water-bearing fluids.

Benchmark free energies and entropies for saturated and compressed water

The Computation of Free Energy of Tip4p Water Using Expanded Ensemble Method

Thermodynamic properties calculation method for moist air: 173 to 647 K

Interfacial thermodynamics of water and six other liquid solvents

Enthalpies and entropies of hydration from Monte Carlo simulations

Effect of Water Content on Thermodynamic Properties of Compressed Hydrogen

Entropy of liquid water as predicted by the two-phase thermodynamic model and data-driven many-body potentials

Thermophysical properties of the SPC/E model of water between 250 and 400 K at pressures up to 1000 MPa

Higher-order virial coefficients of water models

An Equation of State For The TIP4P/2005 Model of Water Including Negative Pressures

Water at Positive and Negative Pressures

Prediction of the ideal-gas thermodynamic properties for water

Seven-Site Effective Pair Potential for Simulating Liquid Water

Density dependence of the entropy and the solvation shell structure in supercritical water via molecular dynamics simulation.

Vapor-liquid equilibrium of water with the MB-pol many-body potential

Evaluation of the Pressure–volume–temperature ( PVT ) Data of Water from Experiments and Molecular Simulations Since 1990

Extension of the IAPWS-95 formulation and an improved calculation approach for saturated properties

Molecular Dynamics Simulation Study on Condensation Coefficients of Different Potential Models for Water

Thermodynamic properties and interfacial tension of a model water–carbon dioxide system

Prediction of the PVT properties of water over wide range of temperatures and pressures from molecular dynamics simulation

Mass Density Fluctuations in Quantum and Classical descriptions of Liquid Water