Abstract:Under different ambient temperatures, the thermal aberration certainly affects the imaging quality of infrared multi-spectral camera. Therefore, an athermalized model of infrared multi-spectral cameras is established, and in this model the ambient infrared multispectral camera is equivalent to a separated dual-lens optical system. In the case of the fixed focal length, the influence of the back focal length on the change of the focal power of the front lens and back lens is analyzed. Now, the variation range of the front and rear lens interval is assumed to be restricted. When the back focal length is smaller than the focal length, the ratio of the absolute value of the focal power of the front lens to the absolute value of the focal power of the back lens decreases with the back focal length increasing. The material of the front lens and the back lens have a longer interval on the thermogram. When the back focal length is greater than the focal length, the scenario becomes exactly opposite. Combined with the judgment method of the positive value and negative value of the focal power on the thermogram, the selection range of materials is constrained by the positive value, negative value, and absolute value of focal power, thus realizing the rapid selection of the optical materials. This method is used to design an athermalized infrared multispectral camera with a waveband of 8–14 μm, a focal length of 50 mm, and an F number of 1.4 in a range from –40 ℃ to +60 ℃. Through the simulation analysis, the value of the athermalized infrared multispectral camera, at the Nyquist frequency of 30 lp/mm reaches 0.39, which is close to the diffraction limit; the root mean square radius of the diffuse spot is smaller than the Airy spot radius of 19.17 μm; the axial aberration is less than 0.02 mm, and the design results show that this method can make the long back-focus infrared optical system maintain stable imaging quality in a large temperature range. The SF6 gas is detected experimentally, and the experimental results demonstrate the excellent optical performance of the system.

New baffle design and analysis of long-wave infrared camera

Design of A Panoramic Long-Wave Infrared Athermal System

Athermal design of long-wave infrared optical system with hybrid refractive/diffractive

Design of Infrared Hybrid Athermal Optical System

The Optical Design of Highly Efficient Cold Shield in IR Detector Based on ASAP

Design of detection optical system with large relative aperture

Influence of temperature on infrared optical system and athermal design

Stray Light Analysis and Suppression of Panoramic Annular Lens

Suppression of Infrared Stray Radiation in Space Optical System

Stray Light Analysis for a Mid-Infrared Plane Grating Spectrometer System

Optical System Design for a Shortwave Infrared Imaging Spectrometer

Stray Light Analysis and Suppression for an Infrared Fourier Imaging Spectrometer

Stray Light Suppression of Different Ground-Based Photoelectric Detection Systems

Suppression of stray light in a catadioptric and re-imaging LWIR system

Research on Stray-Light Suppression Method for Large Off-Axis Three-Mirror Anastigmatic Space Camera

Optimum design of baffle for R-C telescope

Cooled Mid-Infrared Unobscured Three-Mirror System with an Intermediate Image Plane Using Freeform Surfaces

Stray radiation analysis of infrared optical system in multispectral camera

Stray Light Analysis of an On-Axis Three-Reflection Space Optical System

Analysis of Influence of Long Back Focal Length on Athermal Design Based on Infrared Multispectral Camera

A Passive Optical Athermalization Design of MWIR Catadioptric Space Remote Sensor with High Resolution in Geosynchronous Orbit