EXPOSURE SIMULATION DURING CF3I STREAMING FIRE TESTS

Joseph Z. Su,A. Kim,G. Crampton,M. Kanabus-Kaminska

Abstract:EXPERIMENT CF'l extinguishers charged with I- and 2-kg CF?I at 690 and 1345 kPa, respectively, were used in the fire tests. Test fires were heptane pool fires, including a 300 kW fire (0.372-m' square pan. 80% of the UL 2B pan size) and a 900 kW fire (0.836-m' square pan, 72% of the UL 5B pan size). The 2-kg CF31 extinguishers were used to suppress the 900 kW pool fire in a 21 ,000-m3 burn hall. The 1 kg CF31 extinguishers were used to suppress the 300-kW pool fire in a 1 20-m3 compartment and in a 45-m3 compartment. The 45-m' compartment, with an equivalent leakage area of 0.090 m', was connected to a corridor area. Tests proceeded with background data collection, ignition. 20-s preburn, suppression and post-suppression observation. Figure 1 shows a common test set-up used. A thermocouple tree was placed over the square pan to measure flame temperatures, with 6 thermocouples vertically distributed at 2.84, 2.28, 1.72, 1.17,0.60, and 0.20 m. A cross-averaging tube (with 20 holes, 1.1 -mm diameter) was placed beside the pan as a gas sampling probe, which was used to sample fire gases at the fire source. The extinguisher operator stood at 2.4 m from the fire in the burn hall tests and 2.9 m from the Eire in the compartment tests. To prevent exposure to excessive heat and gas byproducts, the operator wore an aluminum heat protective suit with self-contained breathing apparatus during all tests. A heat flux meter (air-cooled, 20 kW/mz range) was placed beside the operator at I .2 m height to measure operator heat exposure. An FTIR spectrometer was dedicated to measure the concentrations of the agent and its TDPs in the operatoi- breathing zone. A gas sampling probe was positioned close to where the operator stood during firefighting. This probe was positioned at 1.5 m height. approximately the operator's nose height. and was connected to the FTIR spectrometer through a gas sampling line. A second FTIR spectrometer was also used to measure the agent and its TDP during the tests. In the burn hall tests, the spectrometei- was connected to the cross-averaging tube (beside the pan), through a heated gas sampling line, to monitor the agent and its TDP at the fire location. During the tests conducted in the 120-m' compartment, the FTIR spectrometer was used for in-situ