Abstract:The stochastic model, together with the functional model, form the mathematical model of observation that enables the estimation of the unknown parameters. In Global Navigation Satellite Systems (GNSS), the stochastic model is an especially important element as it affects not only the accuracy of the positioning model solution, but also the reliability of the carrier-phase ambiguity resolution (AR). In this paper, we study in detail the stochastic modeling problem for Multi-GNSS positioning models, for which the standard approach used so far was to adopt stochastic parameters from the Global Positioning System (GPS). The aim of this work is to develop an individual, empirical stochastic model for each signal and each satellite block for GPS, GLONASS, Galileo and BeiDou systems. The realistic stochastic model is created in the form of a fully populated variance-covariance (VC) matrix that takes into account, in addition to the Carrier-to-Noise density Ratio (C/N0)-dependent variance function, also the cross- and time-correlations between the observations. The weekly measurements from a zero-length and very short baseline are utilized to derive stochastic parameters. The impact on the AR and solution accuracy is analyzed for different positioning scenarios using the modified Kalman Filter. Comparing the positioning results obtained for the created model with respect to the results for the standard elevation-dependent model allows to conclude that the individual empirical stochastic model increases the accuracy of positioning solution and the efficiency of AR. The optimal solution is achieved for four-system Multi-GNSS solution using fully populated empirical model individual for satellite blocks, which provides a 2% increase in the effectiveness of the AR (up to 100%), an increase in the number of solutions with errors below 5 mm by 37% and a reduction in the maximum error by 6 mm compared to the Multi-GNSS solution using the elevation-dependent model with neglected measurements correlations.

Markov Chain, Monte Carlo Global Search and Integration for Bayesian, GPS, Parameter Estimation

A Robust Position Estimation Algorithm for Low-Cost INS/GPS Integrated Navigation System

Complex-valued Bayesian parameter estimation via Markov chain Monte Carlo

Efficient History Matching Using the Markov-Chain Monte Carlo Method by Means of the Transformed Adaptive Stochastic Collocation Method

Maximum likelihood parameter estimation of multiple chirp signals by a new Markov Chain Monte Carlo approach

Bayesian EM approach for GNSS parameters of interest estimation under constant modulus interference

Multiband Delay Estimation for Localization Using a Two-Stage Global Estimation Scheme

An RFID Data and Location Parameter Joint Estimation Based on an Improved MCMC Method.

An Enhanced UWB-Based Range/GPS Cooperative Positioning Approach Using Adaptive Variational Bayesian Cubature Kalman Filtering

Coupled Integration of CSAC, MIMU, and GNSS for Improved PNT Performance

Target Localization Based on Bistatic T/R Pair Selection in GNSS-Based Multistatic Radar System

Application of Adaptive Robust Kalman Filter Base on MCC for SINS/GPS Integrated Navigation

Stochastic modeling with robust Kalman filter for real-time kinematic GPS single-frequency positioning

A Belief Propagation Algorithm for Multipath-based SLAM with Multiple Map Features: A mmWave MIMO Application

High-Accuracy Positioning in Urban Environments Using Single-Frequency Multi-GNSS RTK/MEMS-IMU Integration

A unified model of multi-GNSS and multi‐frequency precise point positioning for the joint estimation of ionospheric TEC and time-varying receiver code bias

Multisource‐multitarget cooperative positioning using probability hypothesis density filter in internet of vehicles

Bayesian Filtering for Joint Multi-User Positioning, Synchronization and Anchor State Calibration

Maritime Moving Target Joint Localization and Kinematic State Estimation Using GNSS-Based Multistatic Radar

Empirical Stochastic Model of Multi-GNSS Measurements

Bayesian-Based Indoor Factory Positioning Using AOA, TDOA and Hybrid Measurements