Abstract:A simple and highly selective flow injection on-line pre-concentration and separation-flame atomic absorption spectrometric method was developed for routine analysis of trace amounts of lead in biological and environmental samples. The selective preconcentration of lead was achieved in a wide range of sample acidity (0.075 to > or = 3 mol L(-1)HNO3) on a microcolumn (145 microL) packed with a macrocycle immobilized on silica gel. The lead retained on the column was effectively eluted with an EDTA solution (0.03 mol L(-1), pH 10.5). Three kinds of potential interferences, i.e., preconcentration inferences from metal ions with an ionic radius similar to that of Pb(II) due to their competition for the cavity of the macrocyle, elution kinetic interferences from ions which form stable complexes with EDTA due to their competition for EDTA, and interferences in the atomizer from residual matrix, were evaluated and compared in view of the read-out mode of the analyte response (peak area vs peak height), column wash step (with vs without), column capacity (50 vs 145 microL), and column shape (conical vs cylindrical). The results showed that a combination of increase in column capacity, quantitation based on peak area, and use of dilute nitric acid for column wash before elution efficiently avoid the above-mentioned potential interferences. With the use of a 145 microL column the present system tolerated up to 0.1 g L(-1) Ba(II), 1 g L(-1) Sr(II), and at least 10 g L(-1) Fe(III), Cu(II), Ni(II), Zn(II), Cd(II), Al(III), K(I), Na(I), CaII), and Mg(II) in the sample digest. Further improvement of the interference tolerance can be achieved by increasing column capacity if more complicated samples need to be analyzed. At a sample loading rate of 3.9 mL min(-1) with 30-s preconcentration, an enrichment factor of 52, a detection limit (3s) of 5 micrograms L(-1) Pb in the digest and a sampling frequency of 63 h(-1) were obtained. The precision (RSD, n = 11) at the 200 micrograms L(-1) level was 1.9%. The enrichment factor and the detection limit can be further improved by increasing sample loading rate without degradation in the efficiency due to the favorable kinetics and low hydrodynamic impedance of the present system. The analytical results obtained by the proposed method for a number of biological and environmental standard reference materials were in good agreement with the certified and recommended values.

Simultaneous flow injection preconcentration of lead and cadmium using cloud point extraction and determination by atomic absorption spectrometry

A Flow Injection On-Line Unequal Flow Complexation Preconcentration Procedure Coupled with Flame Atomic Absorption Spectrometry for Determination of Lead in Tap Water

Air mixing sorption flow injection preconcentration in a knotted reactor coupled with flame atomic absorption spectrometry for determination of trace lead in water

Dual Stage Preconcentration System for Flame Atomic Absorption Spectrometry Using Flow Injection On-Line Ion-Exchange Followed by Solvent Extraction

A flow injection knotted reactor suction elution method coupled with flame atomic absorption spectrometry for the determination of trace lead and zinc in water

Separation, Preconcentration, and Determination of Lead, Cadmium, and Iron Using Cloud Point Extraction with Flame Atomic Absorption Spectrometry

Flow injection on-line solid phase extraction for ultra-trace lead screening with hydride generation atomic fluorescence spectrometry.

An Efficient Flow-Injection System with On-Line Ion-Exchange Preconcentration for the Determination of Trace Amounts of Heavy Metals by Atomic Absorption Spectrometry

Simultaneous and Selective Preconcentration of Trace Cu and Ag by One-Step Displacement Cloud Point Extraction for FAAS Determination.

Simultaneous preconcentration of cadmium and lead in water samples with silica gel and determination by flame atomic absorption spectrometry.

Flow Injection On-Line Separation and Preconcentration for Electrothermal Atomic Absorption Spectrometry. Part 1. Determination of Ultratrace Amounts of Cadmium, Copper, Lead and Nickel in Water Samples

Flow injection on-line preconcentration-graphite furnace atomic absorption spectrometry for the determination of cadmium, copper and nickel

Application of a macrocycle immobilized silica gel sorbent to flow injection on-line microcolumn preconcentration and separation coupled with flame atomic absorption spectrometry for interference-free determination of trace lead in biological and environmental samples

THE DETERMINATION OF TRACE AMOUNTS OF HEAVY-METALS IN WATERS BY A FLOW-INJECTION SYSTEM INCLUDING ION-EXCHANGE PRECONCENTRATION AND FLAME ATOMIC-ABSORPTION SPECTROMETRIC DETECTION

Flow Injection Semi-online Preconcentration Graphite Furnace Atomic Absorption Spectrometry for Determination of Cadmium,Copper and Manganese

Acrylic acid grafted polytetrafluoroethylene fiber as new packing for flow injection on-line microcolumn preconcentration coupled with flame atomic absorption spectrometry for determination of lead and cadmium in environmental and biological samples

Simultaneous on-line pre-concentration and determination of trace metals in environmental samples by flow injection combined with inductively coupled plasma mass spectrometry using silica gel modified with niobium(V) oxide

Flow Injection On-Line Coprecipitation Preconcentration for Electrothermal Atomic Absorption Spectrometry

Preconcentration and Sensitive Methodology for the Determination of Cadmium in Environmental Waters Using Dispersive Liquid-Liquid Microextraction Prior to Analysis by Atomic Fluorescence Spectrometry

On-line Preconcentration and Determination of Trace Metals in Water Samples by Flow Injection Combined with Flame Atomic Absorption Spectrometry via Calix[4]arene Carboxylic Acid Packed Micro-column

Determination of trace cobalt, nickel and cadmium by on-line flow injection analysis with coprecipitation preconcentration FAAS