Formation of solitary microstructure and ablation into transparent dielectric by a subnanosecond laser pulse

V. A. Khokhlov,N. A. Inogamov,V. V. Zhakhovsky,Yu. V. Petrov

DOI: https://doi.org/10.48550/arXiv.1811.11990

2018-11-29

Abstract:Laser ablation in liquid (LAL) is important technique used for formation of nanoparticles (NP). The LAL processes cover logarithmically wide range of spatiotemporal scales and is not fully understood. The NP produced by LAL are rather expensive, thus optimization of involved processes is valuable. As the first step to such optimizations more deep understanding is necessary. We employ physical models and computer simulations by thermodynamic, hydrodynamic, and molecular dynamics codes in this direction. Absorbing light metal expanding into transparent solid or liquid dielectrics is considered. We analyze an interplay between diffusion, hydrodynamic instability, and decrease of surface tension down to zero value caused by strong heating and compression transferring matter into state of overcritical fluids. The primary NPs appear during expansion and cooling of diffusion zone when pressure in this zone drops below critical pressure for a metal. Long evolution from the overcritical states to states below a critical point for a metal and down to critical point of liquid and deeply down to surrounding pressure of 1 bar is followed. Conductive heating of liquid from hot metal is significant.

Mesoscale and Nanoscale Physics,Optics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the multi - scale spatio - temporal dynamics involved in the laser ablation of liquids (LAL), especially the process of forming isolated microstructures and ablation in transparent dielectrics. Specifically, the authors focus on how to gain in - depth understanding of the following aspects through physical models and computer simulations:

1. **Diffusion, hydrodynamic instabilities, and changes in surface tension**: When a metal is strongly heated and compressed into a supercritical fluid state, the surface tension will drop to zero, which will lead to complex transitions between different phases of matter.

2. **Formation mechanism of nanoparticles (NP)**: In particular, during the expansion and cooling process, when the pressure drops below the critical pressure of the metal, primary nanoparticles begin to appear. The article explores the process of evolving from a supercritical state to a state below the critical point and finally reaching the surrounding 1 - bar pressure.

3. **Optimization of the laser ablation process**: Since nanoparticles prepared by LAL are relatively expensive, optimizing this process is very important for improving efficiency and reducing costs. To this end, a deeper understanding of relevant physical and chemical processes is required.

### Specific research contents

- **Expansion of light - absorbing metals in transparent solid or liquid dielectrics**: The researchers analyzed the effects of diffusion, hydrodynamic instabilities, and changes in surface tension on the state of matter.

- **Effects of different pulse durations**: The effects of ultrashort pulses (τL = 100 fs) and sub - nanosecond pulses (τL = 50 ps) were compared, and it was found that although the pulse durations differed significantly, in some cases, their dynamic behaviors were very similar.

- **Energy distribution and ejection mass**: The study found that under different pulse conditions, the energy distribution in the surface layer, the ejected mass, and the trajectory of the contact boundary (CB) were similar.

- **Diffusion mixing in the supercritical state**: In the intermediate stage (about 1 nanosecond), the metal and water were in a supercritical state, resulting in strong diffusion mixing. As the pressure dropped, condensation into clusters and droplets began to occur.

- **Development of Rayleigh - Taylor instability (RTI)**: The study pointed out that during certain time periods, the development of RTI was suppressed by strong diffusion, thus affecting the generation of nanoparticles.

### Summary

The main purpose of the paper is to gain in - depth understanding of the complex physical and chemical phenomena involved in the laser ablation process through theoretical modeling and computer simulations, especially how these processes affect the formation and optimization of nanoparticles. By comparing the experimental results under different pulse conditions, the authors revealed the key mechanisms in the laser ablation process and provided an important reference for future research.