Dynamic Behavior Control of Induction Motor with STATCOM

Majid Dehghani,Peyman Karimyan,Mehradad Abedi,Hadis Karimipour
DOI: https://doi.org/10.48550/arXiv.1811.06035
2018-11-15
Abstract:STATCOMs is used widely in power systems these days. Traditionally, this converter was controlled using a double-loop control or Direct Output Voltage (DOV) controller. But DOV controller do not function properly during a three-phase fault and has a lot of overshoot. Also, the number of PI controllers used in double-loop control is high, which led to complexities when adjusting the coefficients. Therefore, in this paper, an improved DOV method is proposed which, in addition to a reduced number of PI controllers, has a higher speed, lower overshoots and a higher stability in a wider range. By validating the proposed DOV method for controlling the STATCOMs, it has been attempted to improve the dynamical behaviors of induction motor using Matlab/Simulink, and the results indicate a better performance of the proposed method as compared to the other methods.
Systems and Control
What problem does this paper attempt to address?