Abstract:INO-ICAL is a proposed underground particle physics experiment to study the neutrino oscillation parameters by detecting neutrinos produced in the atmospheric air showers. Iron CALorimeter (ICAL) is to have 151 layers of iron stacked vertically, with active detector elements in between the iron layers. The iron layers will be magnetized to enable the measurement of momentum and charge of the $\mu^-$ (or $\mu^+$) produced by $\nu_\mu$ (or $\bar{\nu}_\mu$) interactions. Resistive Plate Chambers (RPCs) have been chosen as the active detector elements due to their large area coverage, uncompromised sensitivity, consistent performance for decades, as well as cost effectiveness. The major factors that decide the physics potential of the ICAL experiment are efficiency, position resolution and time resolution of the large area RPCs. A prototype detector called miniICAL (with 11 iron layers) was commissioned to understand the engineering challenges in building the large scale magnet and its ancillary systems, and also to study the performance of the RPC detectors and readout electronics developed by the INO collaboration. As part of the performance study of the RPC detectors, an attempt is made to improve the position and time resolution of them. Even a small improvement in the position and time resolution will help to improve the measurements of momentum and directionality of the neutrinos in ICAL. The Time-over-Threshold (ToT) of the RPC pulses (signals) is recorded by the readout electronics. ToT is a measure of the pulse width and consequently the amplitude. This information is used to improve the time and position resolution of the RPCs and consequently INO physics potential.

PID performance of the ALICE-TOF detector in Run 2

Development of time-of-flight particle identification for future Higgs factories

Performance of the ATLAS forward proton Time-of-Flight detector in Run 2

The ALICE TPC: Optimization of the Performance in Run 2 and Developments for the Future

The Performance and Development of the Inner Detector Trigger Algorithms at ATLAS for LHC Run 2

The TOTEM nT2 detector: architecture, operation and performance

Alice Alignment, Tracking and Physics Performance Results

Selection and processing of calibration samples to measure the particle identification performance of the LHCb experiment in Run 2

Performance of the ALICE Upgraded Inner Tracking System

Status and performance of the ALICE Fast Interaction Trigger

DIRC-like Time-of-flight Detector for the Experiment at the Super Tau-Charm Facility

Improving Time and Position Resolution of RPC detectors using Time Over Threshold Information

Implementation, performance and physics impact of particle identification at Higgs factories

Calibration and Performance of the Upgraded ALICE Inner Tracking System

Novel strategies at LHCb for particle identification

TOFHIR2: The readout ASIC of the CMS Barrel MIP Timing Detector

First results of the upgraded ALICE Inner Tracking System in LHC Run 3

The charge sensitivity calibration of the upgraded ALICE Inner Tracking System

Determination of the response for the National Ignition Facility particle time of flight (PTOF) detector using single particle counting

The O2 software framework and GPU usage in ALICE online and offline reconstruction in Run 3

The D0 Run II Impact Parameter Trigger