Abstract:Comprehension of wet particle behavior is of great importance in science and engineering. In the past two decades, modeling and simulation for wet particles have been extensively studied because of their various industrial applications. The discrete element method (DEM) is extensively employed to simulate the wet particle behavior. To calculate the wet particle behavior, several capillary force models have been developed so far. Roughly speaking, the capillary force models are classified into two types, namely, the analytical model and the geometrical approximation model. The analytical model is most frequently employed because of its simplicity, though only a small amount of the liquid volume is applicable. The geometrical approximation model has significant advantages because of no theoretical limitation of the liquid volume as well as its high accuracy. Incidentally, the geometrical approximation model usually expresses the liquid bridge shape by the toroidal approximation. However, validation tests for the geometrical approximation model have hardly been performed due to difficulty in incorporating the complex algorithm into the DEM. From the background, this paper aims to prove the superiority and adequacy of the geometrical approximation model in the DEM simulation for wet particles. First, the superiority of the geometrical approximation model to the analytical model is examined in a two-body system. Afterward, the following two types of validation tests are performed: granular collapse and wet powder mixing in a twin-screw kneader. In the granular collapse, the liquid content is set to be less than 4 vol. %. In the twin-screw kneader system, the liquid content is more than 5 vol. %. Through the validation tests, the adequacy of the geometrical approximation model in the DEM is proved because of the agreement between the computational and experimental results in the above systems. Consequently, this study will significantly contribute to a better understanding of wet particle behavior in science and engineering.

On the validation of DEM and FEM/DEM models in 2D and 3D

Investigation of Modeling Non-Spherical Particles by Using Spherical Discrete Element Model with Rolling Friction

Dynamics Analysis of Spatial Mechanisms with Dry Spherical Joints with Clearance Using Finite Particle Method

Validation Tests for Discrete Element Codes Using Single-Contact Systems

Measurement and Simulation Validation of DEM Parameters of Pellet, Sinter and Coke Particles

A novel discrete model for granular material incorporating rolling resistance

Transient rolling friction model for discrete element simulations of sphere assemblies

Linear-frictional contact model for 3D discrete element simulations of granular systems

Influence of rolling friction on single spout fluidized bed simulation

Development of a Collisional Dissipation Rate Model for Frictional Cylinders

A new discrete element method for small adhesive non-spherical particles

2D Numerical Model for Studying Frictional Sliding

Energy Dissipation on an Elastic Interface as a Metric for Evaluating Three Friction Models

Validation study on a toroidal approximation-based capillary force model in the discrete element method simulation

Producing 3D friction loads by tracking the motion of the contact point on bodies in mutual contact

A DEM-based Euler–Lagrange Model for Motion of Particle–fluid Two-Phase Mixtures

Numerical Comparison of Contact Force Models in the Discrete Element Method

DEM Contact Model for Spherical and Polyhedral Particles Based on Energy Conservation

Modeling slow deformation of polygonal particles using DEM

Simulation of the fragmentation and propagation of jointed rock masses in rockslides: DEM modeling and physical experimental verification

A spheropolyhedral-based discrete element lattice Boltzmann method for simulation of non-spherical adhesive particulate flow