Shear viscosity and wall slip behavior of dense suspensions of polydisperse particles

Jing He,Stephanie Lee,Dilhan M. Kalyon

DOI: https://doi.org/10.1122/1.5053702

2018-06-06

Abstract:Shear viscosity and wall slip of dense suspensions of a silicone polymer incorporated with polydisperse particles were investigated. Three types of particles with low aspect ratios were used to achieve a relatively high maximum packing fraction of 0.86. Such a high maximum packing fraction allowed the preparation of suspensions with a wide range of solid volume fractions in the range of 0.62 to 0.82. The wall slip velocities of the suspensions in steady torsional and capillary flows were characterized and determined to be fully consistent with the mechanism of apparent slip layer formation at the wall. Upon wall slip corrections it was found that at shear stresses which are significantly above the yield stress the relative shear viscosity of the suspensions obeys well the Krieger-Dougherty relationship that links the relative shear viscosity behavior of dense suspensions solely to the ratio of the volume fraction over the maximum packing fraction of solids. However, at lower shear stresses that are in the vicinity of the yield stresses the relative shear viscosity becomes functions of both the ratio of the volume fraction over the maximum packing fraction and the shear stress. It is clearly demonstrated that without wall slip analysis the accurate characterization of the relative shear viscosity of dense suspensions is not possible.

Soft Condensed Matter

What problem does this paper attempt to address?

The problem that this paper attempts to solve is about the shear viscosity and wall - slip behavior of high - concentration suspensions (containing polydisperse particles with a low aspect ratio) in shear flow. Specifically, the researchers focus on how to accurately characterize the relative shear viscosity of these suspensions by analyzing the wall - slip phenomenon. The paper mentions that at higher shear stresses, the relative shear viscosity after wall - slip correction follows the Krieger - Dougherty relationship, which is only related to the ratio of the solid volume fraction to the maximum packing fraction \(\phi/\phi_m\). However, at lower shear stresses close to the yield stress, the relative shear viscosity is affected by both \(\phi/\phi_m\) and the shear stress. The study also points out that without wall - slip analysis, it will be impossible to accurately characterize the relative shear viscosity of high - concentration suspensions.

### Formula Presentation

- **Krieger - Dougherty Relationship**:
\[
\eta_r=\frac{\eta}{\eta_0}=(1 - \frac{\phi}{\phi_m})^{-k}
\]
where \(\eta_r\) is the relative shear viscosity, \(\eta\) is the actual shear viscosity, \(\eta_0\) is the shear viscosity of the pure solvent, \(\phi\) is the solid volume fraction, \(\phi_m\) is the maximum packing fraction, and \(k\) is a constant.

- **Relationship between Shear Stress and Shear Rate**:
\[
\tau = \eta\cdot\dot{\gamma}
\]
where \(\tau\) is the shear stress, \(\eta\) is the shear viscosity, and \(\dot{\gamma}\) is the shear rate.

- **Wall - Slip Velocity**:
\[
U_s=\beta\cdot\tau_w
\]
where \(U_s\) is the wall - slip velocity, \(\beta\) is the slip coefficient, and \(\tau_w\) is the wall - surface shear stress.

- **Yield Stress**:
\[
\tau_0 = \text{yield stress}
\]

Through these formulas and experimental data, the researchers can more accurately understand the behavior of high - concentration suspensions under different shear stresses and reveal the influence of the wall - slip phenomenon on shear viscosity.