Mixed Quality of Service in Cell-Free Massive MIMO

Manijeh Bashar,Kanapathippillai Cumanan,Alister G. Burr,Hien Quoc Ngo,H. Vincent Poor

DOI: https://doi.org/10.48550/arXiv.1804.08425

2018-06-19

Abstract:Cell-free massive multiple-input multiple-output (MIMO) is a potential key technology for fifth generation wireless communication networks. A mixed quality-of-service (QoS) problem is investigated in the uplink of a cell-free massive MIMO system where the minimum rate of non-real time users is maximized with per user power constraints whilst the rate of the real-time users (RTUs) meet their target rates. First an approximated uplink user rate is derived based on available channel statistics. Next, the original mixed QoS problem is formulated in terms of receiver filter coefficients and user power allocations which can iteratively be solved through two sub-problems, namely, receiver filter coefficient design and power allocation, which are dealt with using a generalized eigenvalue problem and geometric programming, respectively. Numerical results show that with the proposed scheme, while the rates of RTUs meet the QoS constraints, the $90\%$-likely throughput improves significantly, compared to a simple benchmark scheme.

Signal Processing,Information Theory

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to meet the requirements of hybrid Quality of Service (QoS) in the uplink of Cell - free Massive MIMO (Multiple - Input Multiple - Output) systems. Specifically, the paper focuses on maximizing the minimum rate of non - real - time users (NRTUs) while meeting the rate targets of real - time users (RTUs), and at the same time, the transmit power of each user is constrained.

### Problem Background

With the development of the fifth - generation (5G) wireless communication network, it is required to provide higher spectral efficiency and well - defined Quality of Service (QoS) requirements, especially in supporting real - time services (such as audio - video, video conferencing, web - based seminars and video games). The Cell - free Massive MIMO technology provides a uniform user experience by randomly distributing a large number of access points (APs) in the coverage area to serve a relatively small number of users.

### Specific Problems

The specific problems proposed in the paper are:
- **Objective**: Maximize the minimum rate of non - real - time users (NRTUs) while meeting the QoS requirements of real - time users (RTUs).
- **Constraints**:
- The transmit power of each user is limited.
- The Signal - to - Interference - plus - Noise Ratio (SINR) of real - time users (RTUs) must reach its target value.

### Solutions

To solve the above problems, the paper proposes the following methods:
1. **Approximate user rate**: Derive the approximate uplink user rate based on the available channel statistical information.
2. **Decomposition of the optimization problem**: Decompose the original hybrid QoS problem into two sub - problems:
- **Receive filter coefficient design**: Solved by the generalized eigenvalue problem.
- **Power allocation**: Solved by Geometric Programming (GP).
3. **Iterative algorithm**: Develop an iterative algorithm to alternately solve these two sub - problems until the required accuracy is reached.

### Numerical Results

The numerical results show that the proposed scheme not only makes the rate of real - time users meet the QoS constraints, but also significantly improves the throughput at the 90% confidence level and performs better than the simple benchmark scheme.

### Summary

By decomposing the hybrid QoS problem into two sub - problems of receive filter coefficient design and power allocation, and using the generalized eigenvalue problem and geometric programming to solve them respectively, the paper successfully meets the different Quality of Service requirements for real - time and non - real - time users in the Cell - free Massive MIMO system.