Calibration, validation and uncertainty analysis of a SWAT water quality model

Sushil K. Das,Amimul Ahsan,Md. Habibur Rahman Bejoy Khan,Abdullah Gokhan Yilmaz,Shakil Ahmed,Monzur Imteaz,Muhammad Atiq Ur Rehman Tariq,Md. Shafiquzzaman,Anne W. M. Ng,Nadhir Al-Ansari
DOI: https://doi.org/10.1007/s13201-024-02138-x
IF: 5.411
2024-03-29
Applied Water Science
Abstract:Abstract Sediment and nutrient pollution in water bodies is threatening human health and the ecosystem, due to rapid land use changes and improper agricultural practices. The impact of the nonpoint source pollution needs to be evaluated for the sustainable use of water resources. An ideal tool like the soil and water assessment tool (SWAT) can assess the impact of pollutant loads on the drainage area, which could be beneficial for developing a water quality management model. This study aims to evaluate the SWAT model’s multi-objective and multivariable calibration, validation, and uncertainty analysis at three different sites of the Yarra River drainage area in Victoria, Australia. The drainage area is split into 51 subdrainage areas in the SWAT model. The model is calibrated and validated for streamflow from 1990 to 2008 and sediment and nutrients from 1998 to 2008. The results show that most of the monthly and annual calibration and validation for streamflow, nutrients, and sediment at the three selected sites are found with Nash–Sutcliffe efficiency values greater than 0.50. Furthermore, the uncertainty analysis of the model shows satisfactory results where the p-factor value is reliable by considering 95% prediction uncertainty and the d-factor value is close to zero. The model's results indicate that the model performs well in the river's watershed, which helps construct a water quality management model. Finally, the model application in the cost-effective management of water quality might reduce pollution in water bodies due to land use and agricultural activities, which would be beneficial to water management managers.
water resources
What problem does this paper attempt to address?
The problem that this paper attempts to solve is to evaluate and verify the calibration, validation and uncertainty analysis of the SWAT (Soil and Water Assessment Tool) water quality model at different sites in the middle Yarra River catchment in Victoria, Australia. Specifically, the research aims to: 1. **Calibration and Validation**: Conduct multi - objective and multi - variable calibration and validation of the SWAT model at three different sites in the middle Yarra River catchment, covering the simulation of runoff, sediment and nutrients (such as nitrogen and phosphorus). The calibration time range is from 1990 to 2002, and the validation time is from 2003 to 2008. For sediment and nutrients, the calibration time range is from 1998 to 2004, and the validation time is from 2005 to 2008. 2. **Uncertainty Analysis**: Evaluate the uncertainty of the model through p - factor and d - factor to ensure the reliability of the model results. The p - factor indicates that 95% of the observed data fall within the uncertainty range predicted by the model, and a d - factor close to zero indicates that the uncertainty of the model prediction is low. 3. **Model Performance Evaluation**: Use indicators such as Nash - Sutcliffe Efficiency (NSE), Relative Root Mean Square Error (RSR), Percent Bias (PBIAS) and Coefficient of Determination (R²) to evaluate the performance of the model. These indicators are used to judge whether the performance of the model during the calibration and validation process is satisfactory. 4. **Management Application**: Through the above analysis, provide a scientific basis for water quality management in the middle Yarra River catchment, help formulate effective water quality management strategies, and reduce water pollution caused by land use and agricultural activities. Through these steps, the research aims to improve the application effect of the SWAT model in complex catchments and provide support for the sustainable management of water resources.