Target Detection Method for High-Frequency Surface Wave Radar RD Spectrum Based on (VI)CFAR-CNN and Dual-Detection Maps Fusion Compensation

Yuanzheng Ji,Aijun Liu,Xuekun Chen,Jiaqi Wang,Changjun Yu

DOI: https://doi.org/10.3390/rs16020332

IF: 5

2024-01-15

Remote Sensing

Abstract:This paper proposes a method for the intelligent detection of high-frequency surface wave radar (HFSWR) targets. This method cascades the adaptive constant false alarm (CFAR) detector variability index (VI) with the convolutional neural network (CNN) to form a cascade detector (VI)CFAR-CNN. First, the (VI)CFAR algorithm is used for the first-level detection of the range–Doppler (RD) spectrum; based on this result, the two-dimensional window slice data are extracted using the window with the position of the target on the RD spectrum as the center, and input into the CNN model to carry out further target and clutter identification. When the detection rate of the detector reaches a certain level and cannot be further improved due to the convergence of the CNN model, this paper uses a dual-detection maps fusion method to compensate for the loss of detection performance. First, the optimized parameters are used to perform the weighted fusion of the dual-detection maps, and then, the connected components in the fused detection map are further processed to achieve an independent (VI)CFAR to compensate for the (VI)CFAR-CNN detection results. Due to the difficulty in obtaining HFSWR data that include comprehensive and accurate target truth values, this paper adopts a method of embedding targets into the measured background to construct the RD spectrum dataset for HFSWR. At the same time, the proposed method is compared with various other methods to demonstrate its superiority. Additionally, a small amount of automatic identification system (AIS) and radar correlation data are used to verify the effectiveness and feasibility of this method on completely measured HFSWR data.

environmental sciences,imaging science & photographic technology,remote sensing,geosciences, multidisciplinary

What problem does this paper attempt to address?

### What problems does this paper attempt to solve?

This paper aims to solve the challenges faced by high - frequency surface wave radar (HFSWR) in target detection under complex backgrounds. Specifically, the paper proposes a target detection method based on (VI)CFAR - CNN and dual - detection - map fusion compensation to improve the accuracy and reliability of target detection.

#### Main problems:

1. **Difficulty in target detection under complex backgrounds**:
- The echo signals of HFSWR contain ground clutter, sea clutter, ionospheric clutter, and various noise interferences. These factors make traditional single - frame detection methods prone to false alarms or missed detections, affecting subsequent moving target tracking.

2. **Limitations of traditional detection methods**:
- Traditional constant false - alarm rate (CFAR) detection techniques have limited performance in non - uniform backgrounds and are difficult to effectively distinguish between targets and clutter.

3. **Limitations of deep - learning models**:
- When the entire range - Doppler (RD) spectrum is used as input, the information of a single target only accounts for a small part of the entire RD spectrum information, which poses greater challenges to the target recognition and location of deep - learning networks.

4. **Bottleneck in improving detection performance**:
- Even if the CNN model converges, its detection rate may reach a certain level and cannot be further improved, resulting in a loss of detection performance.

#### Solutions:

To solve the above problems, the paper proposes an innovative target detection method, which mainly includes the following aspects:

1. **(VI)CFAR - CNN Cascade Detector**:
- First, use the (VI)CFAR algorithm to perform primary detection on the RD spectrum, extract two - dimensional window slice data, and input it into the CNN model for further target and clutter identification.

2. **Dual - Detection - Map Fusion Compensation**:
- When the detection rate of the detector reaches a certain level and cannot be further improved, the dual - detection - map fusion method is used to compensate for the loss of detection performance. Weighted fusion is carried out by optimizing parameters, and the connected components in the fused detection map are further processed to compensate the (VI)CFAR - CNN detection result with the independent (VI)CFAR result.

3. **Dataset Construction**:
- Since it is difficult to obtain HFSWR data containing comprehensive and accurate target truth values, the paper adopts the method of embedding targets into the measurement background to construct the RD spectrum dataset. At the same time, a small amount of automatic identification system (AIS) and radar - related data are used to verify the effectiveness and feasibility of the method.

Through this method, the paper not only improves the accuracy and reliability of HFSWR target detection but also provides new research ideas and solutions for target detection tasks of other sensors. Experimental results show that this method has significant application value and also shows good robustness in the case of low signal - to - noise ratio.