Abstract:In an attempt to overcome silanophilic interactions like observed on popular reversed-phase butyl‑bonded silica stationary phases in protein HPLC, a mixed-mode stationary phase based on wide pore silica (3 µm, 300 Å) was prepared by co-immobilization of octyl and 2-pyridylethyl ligands. The surface modification was performed by a new approach using synthesized functional silatranes of the above ligands and prewetted silica. It allowed to generate a dense polymeric siloxane layer on the silica surface. Butyl-bonded silica and octyl/3-aminopropyl-bonded mixed-mode silica phases were prepared for comparison. The modified silicas were subsequently characterized by elemental analysis regarding ligand densities, by solid-state 29Si and 13C cross polarization/magic angle spinning nuclear magnetic resonance spectroscopy for confirming the surface-bonded structure, and by pH-dependent ζ-potential measurements via electrophoretic light scattering providing net surface charge information at distinct pH values. While the classical butyl‑bonded stationary phase revealed negative ζ-potential over the entire pH range investigated (pH 3.5-9.5) due to residual silanols and the mixed-mode octyl/3-aminopropyl-bonded silica positive ζ-potential over the entire pH range, pH-dependent charge reversal was observed at approximately pH 5.5 for the octyl/pyridyl-bonded stationary phase. Then, a test set of proteins differing in hydrophobicities and isoelectric points was employed to evaluate the retention characteristics of all three synthesized stationary phases over the pH range of 3 to 7.5 by acetonitrile-gradient elution reversed-phase HPLC. Under acidic conditions (pH 3) the mixed-mode phases octyl/pyridyl-silica and octyl/aminopropyl-silica showed reduced retention and improved peak shapes due to repulsive interactions preventing silanophilic interactions, while protein separations by their hydrophobicities were achieved (repulsive charge-assisted protein RPLC). Finally, the prepared novel mixed-mode octyl/pyridyl-bonded stationary phase was evaluated in hydrophobic charge induction chromatography mode for protein separation of the same test set. Instead of an organic modifier gradient, elution was enforced by a pH gradient from almost neutral to acidic pH at constant organic modifier content of 10 %. This chromatographic mode showed orthogonal retention characteristics and reversed elution order compared to above organic gradient RP-HPLC. In addition, significantly less organic solvent was used under these conditions, classifying it as a green protein LC technology.

Synthesis of sulfonamide- and sulfonyl-phenylboronic acid-modified silica phases for boronate affinity chromatography at physiological pH

Pyridinylboronic Acid-Functionalized Organic–silica Hybrid Monolithic Capillary for the Selective Enrichment and Separation of Cis-Diol-containing Biomolecules at Acidic Ph

Preparation of Organic-Silica Hybrid Boronate Affinity Monolithic Column for the Specific Capture and Separation of Cis-Diol Containing Compounds.

Preparation and Characterization of Fluorophenylboronic Acid-Functionalized Monolithic Columns for High Affinity Capture of Cis-Diol Containing Compounds.

Synthesis and Characterization of a New Boronate Affinity Monolithic Capillary for Specific Capture of Cis-Diol-containing Compounds.

Preparation and characterization of fluorophenylboronic acid-functionalized affinity monolithic columns for the selective enrichment of cis-diol-containing biomolecules.

A Unique Boronic Acid Functionalized Monolithic Capillary for Specific Capture, Separation and Immobilization of Cis-Diol Biomolecules

Preparation of Boronate Affinity Monolithic Column with High Specific Surface Using Highly Structurally Symmetrical Copolymerizing Reagents

Preparation of restricted-access boronate affinity adsorbent with excellent anti-protein adsorption property for directly extracting small cis -diol molecules from biological matrices

A Wulff-type boronate for boronate affinity capture of cis-diol compounds at medium acidic pH condition.

Chiral phenethylamine synergistic tricarboxylic acid modified ,B-cyclodextrin immobilized on porous silica for enantioseparation

Fluorescent boronic acid polymer grafted on silica particles for affinity separation of saccharides

Fine-Tuning the Specificity of Boronate Affinity Monoliths Toward Glycoproteins Through Ph Manipulation

Synthesis and characterization of macroporous silica modified with optically active poly[N- (oxazolinylphenyl)acrylamide] derivatives for potential application as chiral stationary phases

Wide-pore fully porous mixed-mode octyl/pyridyl-bonded silica material with pH-dependent surface charge reversal for high-performance hydrophobic charge-induction chromatography of proteins

Study on Interaction Between Boronic Acid and Hydroxyethylamines

Fabrication of ionic liquid functionalized silica with different anions and the application in mixed-mode and chiral chromatography

Recent advances in monolithic column-based boronate-affinity chromatography

Preparation and characterization for a new sulfonic acid-functionalized mesoporous silica stationary phase

Preparation and evaluation of two silica-based hydrophilic-hydrophobic and acid-base balanced stationary phases via in-situ surface polymerization

Electrochemically deposited boronate affinity extracting phase for covalent solid phase microextraction of cis-diol biomolecules.