Using a high-stability quartz-crystal microbalance to measure and model the chemical kinetics for gases in and on metals: oxygen in gold

Alan J. Slavin
DOI: https://doi.org/10.48550/arXiv.1709.10022
2018-03-16
Abstract:This paper describes the use of a high-stability quartz-crystal microbalance (QCM) to measure the mass of a gas absorbed on and in the metal electrode on the quartz oscillator, when the gas pressure is low and the gas can be considered as rigidly attached to the metal, so viscosity effects are negligible. This provides an absolute measure of the total mass of gas uptake as a function of time, which can be used to model the kinetic processes involved. The technique can measure diffusion parameters of gases in metals close to room temperature at gas pressures much below one atmosphere, as relevant to surface processes such as atomic layer deposition and model studies of heterogeneous catalysis, whereas traditional diffusion measurements require temperatures over 400oC at gas pressures of at least a few Torr. A strong aspect of the method is the ability to combine the bulk measurement of absorbed mass by a QCM with a surface-sensitive technique such as Auger electron spectroscopy in the same vacuum chamber. The method is illustrated using atomic oxygen, formed under O2 gas at 6x10-5 Torr in the presence of a hot tungsten filament, interacting with the gold electrode on a QCM crystal held at 52 to 120oC. Some of the incident oxygen forms a surface oxide which eventually blocks more uptake, and the rest, about 80%, indiffuses. Surprisingly, the rate of oxygen uptake initially increases with the amount of oxygen previously absorbed; therefore, the measured oxygen uptake with time is reproducible only if pre-adsorption of oxygen conditions the sample. Temperatures above 130oC are necessary for measurable thermal desorption, but all the oxygen can be removed by CO scavenging at all temperatures of these experiments. Simple kinetic models are developed for fitting the experimental data to extract relevant parameters.
Materials Science
What problem does this paper attempt to address?