Abstract:Defects in amorphous-SiO2/Si (a-SiO2/Si) interfaces influence greatly the performance and reliability of Si-based devices. The major interfacial defects that exhibit electronic activity are silicon dangling bonds (so-called Pb defects), which can trap charge carriers and contribute to interfacial charge build-up. In this study, the Pb0 and Pb1 defects at the most technically important a-SiO2/Si(100) interface are investigated quantitatively by using first-principles calculations with realistic interfacial models. Atomistic models of the interface are generated by classical molecular dynamics simulations of Si oxidation with a-SiO2 followed by first-principles structure optimization, and they can reproduce the experimental interfacial properties of the short-range structure parameters, Si oxidation state distribution, and band gap transition. The Pb0 and Pb1 defects are modeled atomistically within the interfacial models, and their g-values and hyperfine parameters are calculated quantitatively by the GIPAW (gauge including projector augmented waves) method. The Fermi contact and hyperfine axis (hf axis) calculated with the Si vacancy model for the Pb0 defect agree well with those obtained experimentally, and the hf axis is coincident with the dangling bond direction determined from the calculated g-tensor and spin density. The Fermi contact and hf axis are calculated for the Pb1 defect with three different models, namely dimer, bridge, and asymmetrically oxidized dimer (AOD), of which the AOD model leads to calculated results that agree well with the experimental ones. However, the AOD model is found to be sensitive to the local structure distortion associated with the softness of the oxygen bridge. What is known as the half AOD is then introduced by deoxidizing one of the two oxygen bridges of the AOD; this may serve as another atomistic model of the Pb1 defect according to the good agreement between the calculated Fermi contact, g-values, and hf axis and the experimental ones. The electronic structures are calculated with the atomistic defect models and show that both defects induce (i) two spin-asymmetric midgap levels in the Si band gap in the neutral state and (ii) spin-symmetric levels in the charged states. The charge transition levels of the defects are calculated with a correction method that is specific to surface/interfacial charge defects, and the calculated levels agree semi-quantitatively with those determined experimentally. The calculated +/0 and 0/− levels are in the Si band gap, with the 0/− level energy being higher than the +/0 one. This implies that both Pb0 and Pb1 defects can trap holes or electrons depending on the position of the Fermi level.

Band alignment of metal/amorphous-oxide interface using atomic orbitals projection of plane-wave: a first principle study at the Al/a-SiO2 interface

Oxynitridization Dependent Interface Control and Band Alignment of AlON/SiON/Si Gate Stacks Grown by Metalorganic Chemical Vapor Deposition

First principles study of band line up at defective metal-oxide interface: oxygen point defects at Al/SiO_2 interface

Band alignment at metal/ferroelectric interfaces: Insights and artifacts from first principles

First principles calculations of the interface properties of amorphous-Al2O3/MoS2 under non-strain and biaxial strain conditions

Mapping Band Alignment Across Complex Oxide Heterointerfaces

Reconstruction of Electrostatic Field at the Interface Leads to Formation of Two-Dimensional Electron Gas at Multivalent (110) Laalo3/Srtio3 Interfaces

Atomic bonding and electrical potential at metal/oxide interfaces, a first principle study

Surface Amorphous Oxides Induced Electron Transfer into Complex Oxide Heterointerfaces

Band offsets at semiconductor-oxide interfaces from hybrid density-functional calculations

Density Functional Calculations on Atomic and Electronic Structures of Amorphous Hfo2/Si(001) Interface

Heterointerface-Driven Band Alignment Engineering and Its Impact on Macro-Performance in Semiconductor Multilayer Nanostructures

Interface Enhanced Functionalities in Oxide Superlattices under Mechanical and Electric Boundary Conditions

Band alignments and defect levels in Si–HfO2 gate stacks: Oxygen vacancy and Fermi-level pinning

Band Alignment and Band Bending at Α-Ga2o3/zno N-N Isotype Hetero-Interface

A First-Principles Investigation of Interfacial Properties and Electronic Structure of SiO2/Al Interface

Density functional theory simulations of amorphous high-κ oxides on a compound semiconductor alloy: a-Al2O3/InGaAs(100)-(4×2), a-HfO2/InGaAs(100)-(4×2), and a-ZrO2/InGaAs(100)-(4×2)

First-principles calculation of the band offset at BaO/BaTiO$_3$ and SrO/SrTiO$_3$ interfaces

Tuning band alignment at a semiconductor-crystalline oxide heterojunction via electrostatic modulation of the interfacial dipole

First-principles Study of Defects in Amorphous-Sio2/si Interfaces

Band Alignment and Interfacial Structure of ZnO/Si Heterojunction with Al2O3 and HfO2 As Interlayers