Abstract:Dual-station cross localization method is another promising technical route to realize cooperative localization in GNSSdenied environment, requiring only two anchor node UAVs instead of at least three nodes if inter-node distance measurement based localization method is used. Traditional Angle-of Arrival (AOA) estimation techniques cannot obtain accurate and highly available angle measurements used for position calculation, for example, optical measuring equipment can provide precise angle measurements but is restricted by weather condition, array antenna can be used in all situations but its measurement error would be too large. In order to acquire precise azimuth and pitch estimations, an optical phase scanning based AOA estimation method is utilized in this work. At the remote antenna unit (RAU), one received microwave signal is applied to a phase modulator (PM), and another received microwave signal coupled with a low-frequency large-voltage sawtooth-wave signal is applied to another PM, this sawtooth-wave signal is utilized to scan the phase of the optical sideband from 0 to 2π. By transmission through a segment of fiber link, the AOA value can be measured by processing the obtained low-frequency electrical signals at the central office (CO). Experimental results demonstrate that the AOA estimation precision could be less than 2.27° when the distance between array elements is half-wavelength of the microwave (d = λ/2 0.015 @10GHz), and smaller than 0.017° if the array elements spacing is bigger than 2m for medium-sized or large-sized UAV. Then the experimental result is applied into dual station cross localization simulation structure of UAV swarm, then localization precision distribution is evaluated in different scenarios, corresponding outcomes indicate that optical phase scanning based high precision AOA estimations are beneficial to cooperative localization, and in order to acquire more accurate cooperative localization results, the positions of anchor node UAVs need to be properly adjusted.

Cooperative Localisation of a GPS-Denied UAV in 3-Dimensional Space Using Direction of Arrival Measurements

A Drone Localization System Based On Multiple Time Delays Fusion

Unmanned aerial vehicle localization using angle of departure from a single base station and dead‐reckoning

Cooperative Localization of Low-cost UAV Using Relative Range Measurements in Multi-UAV Flight

TDOA based Tightly Coupled Sensor Fusion for UAV Positioning in GPS-denied Environment

3D Localization Algorithm of Aircraft Based on CDMA Cellular Network

Non-Centralized Navigation for Source Localization by Cooperative UAVs

A Cooperative Positioning Approach of Unmanned Aerial Vehicles with Accuracy and Robustness.

Cooperative Navigation Method Based on Adaptive CKF for UAVs in GPS Denied Areas

Cooperative Localization for Autonomous Underwater Vehicles Using Parallel Projection

Online Distributed Relative Positioning Utilizing Multiple Cooperative Autonomous Agents

2-D UAV navigation solution with LIDAR sensor under GPS-denied environment

Cooperative Localization Against GPS Signal Loss in Multiple UAVs Flight

Cooperative Localization Based on the Azimuth Angles among Multiple UAVs

Cooperation Localization Method Based on Location Confidence of Multi-UAV in GPS-denied Environment

Hardware-in-the-loop Simulation and Precision Evaluation of UAV Swarm Cooperative Localization Based on AOA Measurement Utilizing Optical Phase Scanning

Cooperative Localization for UAV Systems From the Perspective of Physical Clock Synchronization

GNSS-denied geolocalization of UAVs by visual matching of onboard camera images with orthophotos

A Novel Localization Method for Airborne Multistatic SAR Based on Time Difference of Arrival

Fault-tolerant Localization for multi-UAV cooperative flight

Uav-Aided High-Accuracy Relative Localization Of Ground Vehicles