Abstract:Large-eddy simulations have been conducted to investigate the mechanisms of separated-flow control using a dielectric barrier discharge plasma actuator at a low Reynolds number. In the present study, the mechanisms are classified according to the means of momentum injection to the boundary layer. The separated flow around the NACA 0015 airfoil at a Reynolds number of 63 000 is used as the base flow for separation control. Both normal and burst mode actuations are adopted in separation control. The burst frequency non-dimensionalized by the freestream velocity and the chord length (F+) is varied from 0.25 to 25, and we discuss the control mechanism through the comparison of the aerodynamic performance and controlled flow-fields in each normal and burst case. Lift and drag coefficients are significantly improved for the cases of F+ = 1, 5, and 15 due to flow reattachment associated with a laminar-separation bubble. Frequency and linear stability analyses indicate that the F+ = 5 and 15 cases effectively excite the natural unstable frequency at the separated shear layer, which is caused by the Kelvin-Helmholtz instability. This excitation results in earlier flow reattachment due to earlier turbulent transition. Furthermore, the Reynolds stress decomposition is conducted in order to identify the means of momentum entrainment resulted from large-scale spanwise vortical structure or small-scale turbulent vortices. For the cases with flow reattachment, the large-scale spanwise vortices, which shed from the separated shear layer through plasma actuation, significantly increase the periodic component of the Reynolds stress near the leading edge. These large-scale vortices collapse to small-scale turbulent vortices, and the turbulent component of the Reynolds stress increases around the large-scale vortices. In these cases, although the combination of momentum entrainment by both Reynolds stress components results in flow reattachment, the dominant component is identified as the turbulent component. This indicates that one of the effective control mechanisms for laminar separation is momentum entrainment by turbulent vortices through turbulent transition.

Separation delay via hydro-acoustic control of a NACA4412 airfoil in pre-stalled conditions

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

Laminar Separation Control for Eppler 387 Airfoil Based on Resolvent Analysis

Control of flow separation over an aerofoil by external acoustic excitation at a high Reynolds number

Detached-Eddy Simulations for Active Flow Control

Passive control of dynamic stall using a flow-driven micro-cavity actuator

Passive separation control of a NACA0012 airfoil via a flexible flap

Detached-eddy Simulation of Flow Past a Pitching NACA 0015 Airfoil with Pulsed Actuation

Mechanisms for laminar separated-flow control using dielectric-barrier-discharge plasma actuator at low Reynolds number

Triglobal resolvent-analysis-based control of separated flows around low-aspect-ratio wings

Numerical study of passive and active flow separation control over a NACA0012 airfoil

Stability analysis of separated flows subject to control by zero-net-mass-flux jet

Compressor Airfoil Separation Control Using Nanosecond Plasma Actuation at Low Reynolds Number

Thermal optimization of shock-induced separation in a natural laminar airfoil operating at off-design conditions

Numerical Study of Iced Airfoils with Horn Features Using Large-Eddy Simulation

Numerical Studies of Undulation Control on Dynamic Stall for Reverse Flows

Aeroacoustic investigation of airfoil at near stall conditions

On the Role of the Wall Curvature in the Development of Flows Reattached over an Airfoil through Unsteady Blowing

Numerical and experimental investigations of diffusion-induced boundary layer separation on aero-engine nacelles

Numerical Investigation of Active Flow Control on a Pitching NACA 0015 Airfoil Using Detached-eddy Simulation

The control of flow separation by periodic excitation