On the performance of marine propeller in regular waves, Part I: Single Blade loads in moderate sea states

Fabrizio Ortolani,Ivan Santic,Giulio Dubbioso
DOI: https://doi.org/10.1016/j.oceaneng.2024.118290
IF: 5
2024-06-13
Ocean Engineering
Abstract:During navigation in waves, the mean and fluctuating components of the loads developed by marine propellers changes with respect to calm water condition, as a consequence of the motions that modify the viscous wave of the ship and wave induced velocities. The most critical consequence are the loss of propulsive efficiency, increase of propulsive power demand and increase of emissions that, with the introduction of the EEDI index, have increasingly become pivotal issues in ship design. Contextually, the exacerbation of side effects associated to propeller functioning (pressure pulses vibration and radiated noise) and the reduction fatigue life of the components of the propulsion system occur. The mitigation of all these effects can be achieved both by automatic control of the propulsion system and/or blade shape design. These issues demand a deeper knowledge of the propeller in waves than the usual, focused essentially on the total propulsive loads (propeller thrust and torque). This issue motivated a thorough experimental investigation at CNR-INM by means of measurements of single blade loads during self-propulsion in regular waves for a twin screw propulsive configuration. This paper is dedicated to the analysis and discussion of the single blade loads developed during navigation in moderate sea state (SS3 and SS4) at three different wave lengths ( λ = 0.8, 1.0 and 1.6) and for two different Froude numbers ( FN = 0.17 and 0.25).
engineering, civil, ocean, marine,oceanography
What problem does this paper attempt to address?