Time-Resolved Measurements of the Ultra-low Dissolution Rates of Two-Dimensional Arrays of Platinum Nanoparticles

Azusa Ooi,Towa Kanda,Eiji Tada
DOI: https://doi.org/10.1016/j.electacta.2024.144126
IF: 6.6
2024-03-20
Electrochimica Acta
Abstract:Methods for the quantitative evaluation of platinum (Pt) dissolution are required to allow catalyst lifetimes in polymer electrolyte fuel cells (PEFCs) to be predicted. However, it is challenging to detect very slow Pt dissolution rates occurring at low potential fluctuations, such as during load cycles, as may occur in automotive fuel cells. The dissolution behavior of Pt nanoparticles (NPs) is also greatly affected by the catalyst layer thickness, particle size and inter-particle distance, and it is difficult to assess these effects separately. To address these problems, the present work prepared two-dimensionally distributed Pt NPs using coaxial arc plasma deposition. An online ICP-MS system was subsequently used to evaluate the dissolution rate of these NPs. The results showed that Pt dissolved primarily during cathodic scans in association with potential cycling with a high upper potential limit, such as would occur in a PEFC start-stop cycle. This dissolution was accompanied by the formation of Pt oxide. There was little difference in dissolution behavior between Pt NPs and bulk Pt. An extremely slow time-resolved dissolution rate was successfully measured in the low potential region below 1.0 V vs. a standard hydrogen electrode, indicating that anodic dissolution was the predominant Pt dissolution mechanism. In this case, a clear difference in dissolution behavior between the NPs and bulk metal was observed. The onset potential for NPs dissolution was lower than that for bulk Pt and smaller NPs dissolved faster than larger ones.
electrochemistry
What problem does this paper attempt to address?