Waste to wealth: calcium-magnesium mud-coated polypropylene separator for lithium-ion battery

Boning Zhang,Wentao Liu,Hanting Zhang,Qi Xiao,Suping Huang
DOI: https://doi.org/10.1007/s11581-024-05836-3
IF: 2.961
2024-10-01
Ionics
Abstract:Polyolefins like polypropylene (PP) and polyethylene (PE)-based separators are widely used in the lithium-ion batteries (LIBs). However, applying polyolefin separators is limited in high-performance batteries due to poor electrolyte wettability and thermal stability. In this study, on the basis of the concept of "waste to wealth," a novel approach has been proposed by utilizing waste raw materials of calcium-magnesium mud (CM), incorporating in a slurry coating method applied to a commercial PP separator for enhanced performance surpassing that of the traditional separator. The CM-coated PP (CM@PP) separator demonstrated better thermal stability and electrolyte compatibility, higher Li-ion conductivity, and lower interfacial resistance than the uncoated PP separator. Cycling and rate performance of CM@PP separator assembled battery were higher compared to those of the uncoated PP separator assembled battery. The LiFePO 4 |Li battery with the CM@PP separator rendered a high discharge capacity of 154 mAh g −1 at 1 C and a capacity retention rate of 93.0% after 200 cycles. These results indicate that CM-coated PP separator is a promising strategy to improve the safety and electrochemical performance of LIBs. The low cost of CM emphasized the superiority of this facile separator modification method.
chemistry, physical,physics, condensed matter,electrochemistry
What problem does this paper attempt to address?