The 2nd International Conference on Intelligent Control and Information Processing Static Error Estimation for a Class of Second-order Pd Controlled Mechanical Systems

J. Gu,K. Zheng,Junqiang Ma,Xingcheng Wang,G. Gu,K. Zheng,X. Wang

Abstract:This paper analyzes the static error of a class of second-order mechanical systems with PD control caused by dry friction. The results show that if the closed-loop system is over damped or critically damped, the static servo error may be the largest for the motion starting from the steady state. While the static servo error can be regulated according to the initial condition, if the closed-loop system is under damped. Finally, the simulations for a simple one-degree-of-freedom (lDOF) mass-spring system are carried out to illustrate our results. Position control is one of important issues of motion control for mechanical systems. However, the external dis­ turbance and the uncertainties usually generate the many problems in control design. Especially, the dry friction force, which has nonsmooth nature, may cause the limit cycles and the large servo errors [4]-[6]. Many studies are presented to characterize the phenomena of dry friction in the past two decades, such as [1]-[3]. In order to achieve the accuracy requirement and the response performance, many advanced design methods are developed based on model based control [7]-[14]. Although zero steady-state error may be obtained through these model-based control schemes, their algorithms and the complexity of the algorithms mainly depend on the adopted friction model. In a practical sense, a trade-off between the complexity of the control algorithm and the performance requirement is usually made to construct a feasible controller. As the simplest controller, PD controller has been widely imple­ mented, through the static servo error many arise [15]-[17]. [18] proposes that any static Lipschitz feedback can not achieve asymptotically stability of the closed-loop system. The analysis in [19] shows that there exist a stationary set related to the dry friction force and the control parameters for the PD controlled positioning systems. In fact, the final servo error is highly related to the initial condition of the motion control system, since the systems are usually nonlinear. In other words, we can improve the positioning accuracy through the proper selection of the initial position where the system starts. This paper attempts to discuss the relation between the points in the stationary set of the PD controlled systems and the initial positions where the trajectories start. A class of PD controlled second-order mechanical systems with the discontinuous friction force are considered as the control plants. The closed-loop system is modeled by two switched linear differential equations with the switching condition zero motion …