Abstract:Research on the photoelectrocatalytic (PEC) oxidation of organic contaminants, the role of cathodes during photocatalysis has usually been disregarded. This paper reports a study of the PEC decomposition of aniline and salicylic acid with simultaneous production of hydrogen peroxide in a divided reactor using TiO2 as a photoanode. Two types of TiO2 electrode were used. Thermal oxidation electrodes (TO–TiO2) were made by oxidation of titanium metal sheet; sol–gel electrodes (SG–TiO2) were made by coating and then heating a layer of titania gel on titanium sheet. Saturated photocurrent was used to carry out an initial characterization and optimization of both electrode types. The best TO–TiO2 electrodes were prepared by heating titanium at 600–700°C in air. For the SG–TiO2 electrodes, optimum performance was obtained by heating at 500°C. These electrodes were then used to photodegrade aniline and salicylate. The SG–TiO2 electrodes turned out to be superior to the TO–TiO2 electrodes in terms of PEC rate under the same conditions but the difference in rate between the two electrodes was comparable under a high enough bias potential. The most important factors affecting the production of H2O2 in the cathode compartment are presented. The current efficiencies for the accumulation of H2O2 were remarkably affected by the cathode used, pH value, current density, and metal cations such as copper and iron ions. An expected H2O2 concentration could be obtained by controlling either the magnitude of the photocurrent or illumination time. The maximum current efficiency for the cathodic reduction of oxygen to H2O2 was as high as 90.1% when graphite was used as the cathode. Compared to the SG–TiO2 electrode, the TO–TiO2 electrode had a higher light to electricity conversion efficiency, thus it turned out to be more suitable for the production of H2O2. Furthermore, the role of in-situ reduced oxygen species in the PEC decomposition of aniline was evaluated.

Degradation of bisphenol A in aqueous solution by H2O2-assisted photoelectrocatalytic oxidation

[Degradation of BPA in Aqueous Solution by Interaction of Photocatalytic Oxidation and Ferrate (VI) Oxidation].

Elimination of Bisphenol A with Visible Light-Enhanced Peroxydisulfate Activation Process Mediated by Fe3+-nitrilotriacetic Acid Complex.

A H2O2 Oxidation Approach to Ti3C2/TiO2 for Efficient Photocatalytic Removal of Distinct Organic Pollutants in Water.

Photocatalysis of Bisphenol A by an Easy-Settling Titania/titanate Composite: Effects of Water Chemistry Factors, Degradation Pathway and Theoretical Calculation.

Single-crystalline Rutile TiO2 Nanorod Array on Flexible Ti Substrates for Efficient Photoelectrocatalytic Degradation of Phenol in Water

Photoelectrocatalytic Destruction of Organics Using TiO2 As Photoanode with Simultaneous Production of H2O2 at the Cathode

Photochemical Protection of Reactive Sites on Defective TiO<sub>2–<i>x</i></sub> Surface for Electrochemical Water Treatment

A biophotoelectrocatalytic system for pollutant removal based on carbon fiber cloth supported TiO2 photoanode with oxygen vacancy defects and CuO/g-C3N4 photocathode

Electrochemical Degradation of Bisphenol A on Different Anodes.

Preparation and performance of aerogel-based BiOI/TiO 2 heterojunction photoelectrocatalytic electrodes

In-situ Generation of H2O2 in Cathode to Enhance the Photoelectrocatalytic Degradation of EDTA in Water

Photocatalytic Degradation of Bisphenol A Using Ti-substituted Hydroxyapatite

Polyoxometalates/TiO2 Photocatalysts with Engineered Facets for Enhanced Degradation of Bisphenol A Through Persulfate Activation

Polydopamine/graphite sheet electrode for highly efficient electrocatalytic hydrogen peroxide generation and bisphenol A removal

Laccase-coupled photoelectrocatalytic system for highly efficient degradation of bisphenol A

Photocatalytic degradation of bisphenol A using titanium dioxide@nanodiamond composites under UV light illumination

Design of BDD-TiO2 Hybrid Electrode with P−N Function for Photoelectrocatalytic Degradation of Organic Contaminants

Efficient degradation of bisphenol A over facilely optimized ternary Ag/ZnO/ZnAl‒LDH composite with enhanced photocatalytic performance under visible light irradiation

Degradation of bisphenol A through Ti–BiOI/ZIF-8/peroxymonosulfate (PMS): Catalyst preparation, experimental design and catalytic mechanism

Photochemical Anti-Fouling Approach for Electrochemical Pollutant Degradation on Facet-Tailored TiO2 Single Crystals.