Abstract:A passive and active neutron measurement system has been developed within the MICADO H2020 project, to estimate the nuclear material mass inside legacy waste drums of low and intermediate radioactivity levels. Monte-Carlo simulations were performed to design a transportable neutron system allowing both passive neutron coincidence counting and active interrogation with the Differential Die-away Technique. However, the calibration coefficients representing the signal of interest (due to nuclear material) in these two measurement modes may vary by a large amount depending on the properties of the matrix of the nuclear waste drum. Therefore, this paper investigates matrix effects based on 104 Monte-Carlo calculations with different waste drums, based on Taguchi experimental design with a range of densities, material compositions, filling levels and nuclear material masses. A matrix correction method is studied using machine learning algorithms. The matrix effect on the neutron signal is deduced from the signal of internal neutron monitors located inside the measurement cavity, and from a transmission measurement with an AmBe neutron source. Those quantities can be assessed experimentally and are used as explanatory variables for the definition of a predictive model of the simulated calibration coefficient, either in passive or in active mode. A multi-linear regression model of the calibration coefficient based on ordinary least square (OLS) is built and compared to the Random Forest (RF) machine-learning algorithm, and to the multi-layer perceptron artificial neural network (MLP). In passive neutron coincidence counting, the residual error of the regression is lower for the MLP and RF than for OLS. The agreement between the predicted calibration coefficients of four mock-up drums used as test is better than 17% and 3%, respectively, with the MLP and RF methods, while three predictions are out of the 95% confidence level range with OLS. In active neutron interrogation, similar conclusions are drawn. The prediction of the calibration coefficient for the four mock-up drums is better than 12%, 35% and 72% for the respective MLP, RF and OLS methods. In conclusion, MLP and RF regression model demonstrates more accurate results of the quantities of interest than the traditional OLS method. The future steps will focus on matrix heterogeneities, experimental validation, improving our models and testing new regression approaches.

Implementation of variance-reduction techniques for Monte Carlo nuclear logging calculations with neutron sources

Monte Carlo Simulation In Nuclear Well Logging

Development of New Variance Reduction Methods Based on Weight Window Technique in Rmc Code

A Combined Weight Window and Biasing Approach Based on A Subspace Importance Map in the Monte Carlo Simulation of A Gamma-Gamma Lithodensity Logging Tool Response with the Revised Mcldl Code

Monte Carlo Simulation on N-Γ Density Logging Using A D-D Neutron Generator

Note on the potential to increase the accuracy of source term calculations for spent nuclear fuel

Research on Monte Carlo Global Variance Reduction Method Combining Source Bias and Weight Window

Effectiveness of Radiation Transport Variance Reduction Methods for Wide-Area Environmental Contamination Assay Applications

Development and Validation of an Automated Weight Window Generator for Reactor Monte Carlo Programs

Reducing Variance in Nuclear Monte Carlo Simulations Through Deep Learning Post-Processing Techniques in the Gaming Domain

Improving calculation efficiency of neutron multiplicity counting by sequential detection events simulation

Application of Machine Learning to MICADO passive and active neutron measurement system for the characterization of radioactive waste drums

The use of a Monte Carlo method for uncertainty calculation, with an application to the measurement of neutron ambient dose equivalent rate

Monte-Carlo Methods for the Neutron Transport Equation

Monte Carlo Simulation Of C/O Energy Spectrum Well-Logging

The Monte Carlo Multiply Scattered Components (mcmsc) Approach for Natural Gamma-Ray Logging Tool Interpretation

Open-Source Optimization of Hybrid Monte-Carlo Methods for Fast Response Modeling of NaI(Tl) and HPGe Gamma Detectors

Neutron Measurements and Monte Carlo Simulations of Spent Nuclear Fuel in Dry Cask Storage Using a New Remote Monitoring System Prototype

Weighted Monte Carlo solution of neutron kinetics equations

Variance Analysis for Passive Neutron Multiplicity Counting

Study on domain decomposition method for Monte Carlo simulation of neutron transport