Abstract:Exposure to ultraviolet (UV) radiation may cause the significant degradation of many materials. UV radiation causes photooxidative degradation which results in breaking of the polymer chains, produces free radical and reduces the molecular weight, causing deterioration of mechanical properties and leading to useless materials, after an unpredictable time. Polystyrene (PS), one of the most important material in the modern plastic industry, has been used all over the world, due to its excellent physical properties and low-cost. When polystyrene is subjected to UV irradiation in the presence of air, it undergoes a rapid yellowing and a gradual embrittlement. The mechanism of PS photolysis in the solid state (film) depends on the mobility of free radicals in the polymer matrix and their bimolecular recombination. Free hydrogen radicals diffuse very easily through the polymer matrix and combine in pairs or abstract hydrogen atoms from polymer molecule. Phenyl radical has limited mobility. They may abstract hydrogen from the near surrounding or combine with a polymer radical or with hydrogen radicals. Almost all synthetic polymers require stabilization against adverse environmental effects. It is necessary to find a means to reduce or prevent damage induced by environmental components such as heat, light or oxygen. The photostabilization of polymers may be achieved in many ways. The following stabilizing systems have been developed, which depend on the action of stabilizer: (1) light screeners, (2) UV absorbers, (3) excited-state quenchers, (4) peroxide decomposers, and (5) free radical scavengers; of these, it is generally believed that excited-state quenchers, peroxide decomposers, and free radical scavengers are the most effective. Research into degradation and ageing of polymers is extremely intensive and new materials are being synthesized with a pre-programmed lifetime. New stabilizers are becoming commercially available although their modes of action are sometimes not thoroughly elucidated. They target the many possible ways of polymer degradation: thermolysis, thermooxidation, photolysis, photooxidation, radiolysis etc. With the goal to increase lifetime of a particular polymeric material, two aspects of degradation are of particular importance: Storage conditions, and Addition of appropriate stabilizers. A profound knowledge of degradation mechanisms is needed to achieve the goal.

Degradation processes in polyolefins with phenolic stabilizers subjected to ionizing or non-ionizing radiation

A Comparative Study of Gamma-Ray Irradiation-Induced Oxidation: Polyethylene, Poly (Vinylidene Fluoride), and Polytetrafluoroethylene

GC investigation of post-irradiation oxidation phenomena on polypropylene

INSIGHT INTO THE OXIDATIVE DEGRADATION OF PHENOLIC RESIN DESTINED FOR THE CORROSION PROTECTION OF METALLIC SURFACES

Modifications of Polymers through the Addition of Ultraviolet Absorbers to Reduce the Aging Effect of Accelerated and Natural Irradiation

The Effect of High-Energy Ionizing Radiation on the Mechanical Properties of a Melamine Resin, Phenol-Formaldehyde Resin, and Nitrile Rubber Blend

The effects of atomic oxygen and ion irradiation degradation on multi-polymers: A combined ground-based exposure and ReaxFF-MD simulation

Synergism of the action of some stabilisers against the destruction of polymer materials

Radiolytic Degradation and Mechanism Study of Electron Beam-Irradiated Solutions of 4-Tert-octylphenol

Enhanced photostability of polyvinyl chloride films through antipyrine derivatives: a comprehensive study on UV resistance and degradation inhibition

Photodegradation and photostabilization of polymers, especially polystyrene: review

Stability Qualification of Resins/Metallic Oxide Composites for Surface Oxidative Protection

Spin Trapping Analysis of Radical Intermediates on the Thermo-Oxidative Degradation of Polypropylene

Degradation Behavior and Mechanisms of Several Polymeric Insulating Materials Exposed to Heat and Radiation

Study on the Photo-Degradation and Photo-Stabilization of Poly(p-Phenylene Benzobisoxazole)

Mechanistical studies on the electron-induced degradation of polymers: polyethylene, polytetrafluoroethylene, and polystyrene

Influence of Binary Combined Systems of Antioxidants on the Stabilization of Peroxide‐cured Low‐density Polyethylene

Isobornyl and Isocamphyl Photostabilizers in Poly(lactic acid)-Based Electrospun Fibers

Differences in the Residual Behavior of a Bumetrizole-Type Ultraviolet Light Absorber during the Degradation of Various Polymers

Evaluation of the stabilizing effect and ageing time indicator properties of poly(flavonoids) in a cyclic olefin copolymer

Investigation of the Impact of Chemical Modifications on the Photostability of Polymethyl Methacrylate