Effect of impurity components in titanium gypsum on the setting time and mechanical properties of gypsum-slag cementitious materials

Yilin Li,Zhirong Jia,Shuaijun Li,Peiqing Li,Xuekun Jiang,Zhong Zhang,Bin Yu

DOI: https://doi.org/10.1515/rams-2024-0005

2024-01-01

REVIEWS ON ADVANCED MATERIALS SCIENCE

Abstract:Abstract The use of titanium gypsum instead of gypsum as a raw material for the preparation of gypsum-slag cementitious materials (GSCM) can reduce the cost and improve the utilization of solid waste. However, titanium gypsum contains impurities such as Fe 2 O 3 , MgO, and TiO 2 , which make its effect on the performance of GSCM uncertain. To investigate this issue, GSCM doped with different ratios of Fe 2 O 3 , MgO, and TiO 2 were prepared in this study, the setting time and the strength of GSCM at 3, 7, and 28 days were tested. The effects of different oxides on the performance of GSCM were also investigated by scanning electron microscopy, energy spectrum analysis, X-ray diffraction analysis, and thermogravimetric analysis. The experimental results showed that Fe 2 O 3 , MgO, and TiO 2 all had a certain procoagulant effect on GSCM and a slight effect on the strength. Through micro-analysis, it was found that the main hydration products of GSCM were AFt phase and calcium–alumina–silicate–hydrate (C–(A)–S–H) gels. Fe-rich C–(A)–S–H gels were observed with the addition of Fe 2 O 3 , and Mg(OH) 2 and M–S–H gels were observed with the addition of MgO. The addition of TiO 2 did not result in new hydration products from GSCM.

materials science, multidisciplinary,nanoscience & nanotechnology

What problem does this paper attempt to address?

The paper attempts to address the following issues:

1. **Research gap in replacing natural gypsum with titanium gypsum in gypsum slag cementitious materials (GSCM)**: Current research on industrial by-product gypsum mainly focuses on phosphogypsum and desulfurization gypsum, while there is less research on replacing natural gypsum with titanium gypsum in GSCM.

2. **Unclear impact of specific oxide components in titanium gypsum on the setting time and mechanical properties of GSCM**: Titanium gypsum contains impurities such as Fe₂O₃, MgO, and TiO₂. The specific impact of these components on the setting time and mechanical properties of GSCM is not yet clear.

3. **Changes in the microstructure and mechanism of action after incorporating different oxide components into GSCM**: Existing studies do not clearly explain the impact of different oxide components on the microstructure of GSCM and their specific mechanisms of action after incorporation.

To address the above issues, researchers selected three oxide components, Fe₂O₃, MgO, and TiO₂, to be incorporated into GSCM separately. They studied the impact of these three oxide components on the setting time and mechanical properties of GSCM and explored their mechanisms of action, hoping to solve the technical problems of effectively applying titanium gypsum in GSCM.