Abstract:U is a long-lived radioactive isotope with a half-life of 2.342(3) ×10 a, which produced principally by thermal neutron capture on U. U is potentially applied in geological research and nuclear safeguards. Accelerator mass spectrometry (AMS) is presently the most sensitive technique for the measurement of U. A method for AMS measurement of long-lived heavy ion U was developed at CIAE with the set up the AMS dedicated injector and the newly proposed PbO2 molecular ions for the simulation of U ion transport. A sensitivity of lower than 10 has been achieved for isotopic ratio U/U in present work. INTRODUCTION U is a long-lived radioactive isotope with a half-life of 2.342(3) ×10 a, mainly produced by the thermal neutron induced U(n,γ) U reaction. The isotopic ratio of U/U in nature is about 10, depending strongly on the integral thermal neutron flux received by the material. This makes U usable as an integrating neutron monitor over the last 100 million years [1], and potentially applicable in geological research [2]. The isotopic ratio of U/U could also be used as a “fingerprint” for indicating the presence of neutronirradiated uranium usually originated from nuclear activities [3]. Recently, several efforts have been made to measure U in environmental samples using techniques based on mass spectrometry such as high-resolution inductively coupled plasma spectrometry (HR-ICPMS), thermal ionization mass spectrometry (TIMS) and accelerator mass spectrometry (AMS). However, detection limits with conventional mass spectroscopy for U/U are ~10, leading to errors larger than 50% for uranium ore samples[4, 5]. Therefore the measurement of natural U is difficult or even impossible without AMS. AMS offers significant advantages over conventional mass spectroscopic methods in high sensitivity, smaller sample size, relatively free from isomer and molecular-ion interferences, and shorter measurement time. AMS measurement of actinides was presented firstly by IsoTrace facility X.L. Zhao et al. of Toronto group [6], in which the U/U is lower than 5×10 in a natural uranium ore from Cigar Lake deposit in Canada. The natural U/U has also been measured by several other groups, such as: VERA [7], ANU [8], LLNL [9], ANSTO [10], Munich [11], ETH [12] and Israel Weizmann Institute [13]. In this paper, a method for AMS measurement of longlived heavy ion U developed on the HI-13 Accelerator at China Institute of Atomic Energy (CIAE) is reported. The unique features include establishing of the AMS dedicated injector and the newly proposed PbO2 molecular ions for the simulation of U ion transport. THE AMS DEDICATED INJECTOR There is a general rule in AMS that a high mass resolution analyzer is needed to separate the neighboring interference and a high energy resolution analyzer is required to clip the tail of the high energy. The original injector setup at CIAE [14] with the mass resolution of M M Δ ~220, could not satisfy the requirement for AMS measurement of heavy isotopes (e.g., U, Hf, Sm). Therefore, a high resolution dedicated injector for AMS was developed, as shown in Fig. 1. The new injector adopts achromatic technique, which consists of a 90o electrostatic analyzer (ESA) and a 112o double-focusing analyzing magnet (MA). A triplet electric quadruple lens and a single electric quadruple lens were mounted at the entrance and the exit of the ESA beam line, respectively, for ions focusing. This spherical 90o ESA with 750 mm radius, has maximum electric field strength of 4 kV/cm and provides both horizontal and vertical focusing. The 112o double-focusing MA with a bending radius of 800 mm, has a maximum magnetic field of 1.3 T. The energy resolution of the electrostatic deflector

Precise measurement of the thermal and stellar $^{54}$Fe($n, γ$)$^{55}$Fe cross sections via AMS

Measurement of the stellar $^{58}$Ni$(n,γ)^{59}$Ni cross section with AMS

Accelerator mass spectrometry for long-lived heavy ion 236 u at ciae *

AMS measurement of 53Mn and its initial application at CIAE

The thermal neutron capture cross section of the radioactive isotope $^{60}$Fe

Cross-section Measurements for 58,60,61ni(n, Α)55,57,58fe Reactions in the 4.50 – 5.50 MeV Neutron Energy Region *

Concurrent application of ANC and THM to assess the $^{13}{\rm C}(α,n)^{16}{\rm O}$ absolute cross section at astrophysical energies and possible consequences for neutron production in low-mass AGB stars

High-resolution cross section measurements for neutron interactions on Y with incident neutron energies up to 95 keV

Low energy alpha-nucleus optical potential studied via (a,n) cross section measurements on Te isotopes

Nuclear Structure Studies of Short-Lived Neutron-Rich Nuclei with the Novel Large-Scale Isochronous Mass Spectrometry at the FRS-ESR Facility

Intermediate mass and heavy Galactic cosmic-ray nuclei: the case of new AMS-02 measurements

Machine-Learning-Enabled Measurements of Astrophysical (p,n) Reactions with the SECAR Recoil Separator

Measurement of the Cross Section at n_TOF and Its Astrophysical Implications for the Chemical Evolution of the Universe

Cross-section measurements for the <SUP>58,60,61</SUP>Ni(<i>n</i>, )<SUP>55,57,58</SUP>Fe reactions at 8.50, 9.50 and 10.50 MeV neutron energies

High-precision mass measurement of $^{56}$Cu and the redirection of the rp-process flow

measurements and the astrophysical reaction rate

Production and measurement of a stellar neutron spectrum at 30 keV

Precise validation of neutron cross section data bases using a lead slowing down spectrometer and simulation from 0.1 eV to 40 keV. Methodology and data on thin and thick targets and data bases adjustement

Cross sections of theFe56(n,α)Cr53andFe54(n,α)Cr51reactions in the MeV region

Energy, strength, and alpha width measurements of $E_{\rm{c.m.}} = 1323$ and $1487$ keV resonances in $^{15}$N($α,γ$)$^{19}$F

Methodology for measuring photonuclear reaction cross sections with an electron accelerator based on Bayesian analysis