Abstract:The use of Computational Fluid Dynamics (CFD) tools for integrated simulations of gas turbine components has emerged as a promising way to predict undesired component interactions thereby giving access to potentially better engine designs and higher efficiency. In this context, the ever-increasing computational power available. worldwide makes it possible to envision integrated massively parallel combustion chamber-turbomachinery simulations based on Large-Eddy Simulations (LES). While LES have proven their superiority for combustor simulations, few studies have employed this approach in complete turbomachinery stages. The main reason for this is the known weaknesses Of near wall flow modeling in CFD. Two approaches exist: the wall-modeled LES, where wall flow physics is modeled by a law-of-the-wall, and the wall-resolved LES where all the relevant near wall physics is to be captured by the grid leading to massive computational cost increases. This work investigates the sensitivity of wall-modeled LES of a high-pressure turbine stage. The code employed, called TurboAVBP, is an in-house LES code capable of handling turbomachinery configurations. This is possible through an LES-compatible approach with the rotor/stator interface treated based on an overset moving grids method. It is designed to avoid any interference with the numerical scheme, allow the proper representation of turbulent structures crossing it and run on massively parallel platforms. The simulations focus on the engine-representative MT1 transonic high-pressure turbine, tested by QinetiQ. To control the computational cost, the configuration employed is composed of I scaled stator section and 2 rotors. The main issues investigated are the effect of mesh resolution and the effect of sub-grid scale models in conjunction with wall modeling. The pressure profiles across the stator and rotor blades are in good agreement with the experimental data for all cases. Radial profiles at the rotor exit (in the near and far field) show improvement over RANS predictions. Unsteady flow features, inherently present in LES, are, however, found to be affected by the modeling parameters as evidenced by the obtained shock strengths and structures or turbulence content of the different simulations.

Mesh Resolution Effect on 3D RANS Turbomachinery Flow Simulations

Adaptive Mesh Refinement for Complex Turbomachinery Flow

Flow Computations of Multi-Stages by URANS and Flux Balanced Mixing Models

Adaptive Mesh Refinement Method Based Investigation of the Interaction Between Shock Wave, Boundary Layer, and Tip Vortex in a Transonic Compressor

Verification of Anisotropic Mesh Adaptation for Unsteady Mixing and Reacting Flow

Cell Size Effect on the Numerical Solution of Navier-Stokes Equations

Development of a Numerical Approach for the CFD Simulation of a Gear Pump under Actual Operating Conditions

Direct Numerical Simulation of Wind-Driven Turbulent Flow (investigation of the Computational Accuracy)

Cell Size Effect on Computational Fluid Dynamics: The Limitation Principle for Flow Simulation

Large Eddy Simulation Of A High Pressure Turbine Stage: Effects Of Sub-Grid Scale Modeling And Mesh Resolution

Coarse grid projection methodology: A partial mesh refinement tool for incompressible flow simulations

Comparison of different mesh types in numerical simulation of a ship propeller

Adaptive Mesh Refinement for Ddes Simulation on Transonic Compressor Cascade with Unstructured Mesh

Grid Convergence Study on a Finite Volume Code NSAWET

On the Application of Gradient Based Reconstruction for Flow Simulations on Generalized Curvilinear and Dynamic Mesh Domains

Mesh and model requirements for capturing deep-stall aerodynamics in low-Mach-number flows

Investigation on the Adaptive Mesh Refinement Method With Unstructured Grid For Transonic Compressor

Application of mesh refinement to relativistic magnetic reconnection

Effect of Mesh Quality on Flux Reconstruction in Multi-Dimensions

Analysis of a Meshless Solver for High Reynolds Number Flow

Effects of computational grids and turbulence models on numerical simulation of centrifugal pump with CFD