Abstract:Wireless networks are built upon a shared medium that makes it easy for adversaries to launch jamming-style attacks. These attacks can be easily accomplished by an adversary emitting radio frequency signals that do not follow an underlying MAC protocol. Jamming attacks can severely interfere with the normal operation of wireless networks and, consequently, mechanisms are needed that can cope with jamming attacks. In this paper, we examine radio interference attacks from both sides of the issue: first, we study the problem of conducting radio interference attacks on wireless networks, and second we examine the critical issue of diagnosing the presence of jamming attacks. Specifically, we propose four different jamming attack models that can be used by an adversary to disable the operation of a wireless network, and evaluate their effectiveness in terms of how each method affects the ability of a wireless node to send and receive packets. We then discuss different measurements that serve as the basis for detecting a jamming attack, and explore scenarios where each measurement by itself is not enough to reliably classify the presence of a jamming attack. In particular, we observe that signal strength and carrier sensing time are unable to conclusively detect the presence of a jammer. Further, we observe that although by using packet delivery ratio we may differentiate between congested and jammed scenarios, we are nonetheless unable to conclude whether poor link utility is due to jamming or the mobility of nodes. The fact that no single measurement is sufficient for reliably classifying the presence of a jammer is an important observation, and necessitates the development of enhanced detection schemes that can remove ambiguity when detecting a jammer. To address this need, we propose two enhanced detection protocols that employ consistency checking. The first scheme employs signal strength measurements as a reactive consistency check for poor packet delivery ratios, while the second scheme employs location information to serve as the consistency check. Throughout our discussions, we examine the feasibility and effectiveness of jamming attacks and detection schemes using the MICA2 Mote platform.

The feasibility of launching physical layer attacks in visible light communication networks

6G Networks Physical Layer Security Using RGB Visible Light Communications

Securing Wireless Systems Via Lower Layer Enforcements

Physical Layer Security for Visible Light Communication Systems: A Survey

The Feasibility of Launching and Detecting Jamming Attacks in Wireless Networks.

Channel Surfing and Spatial Retreats

An enhanced indoor visible light communication physical‐layer security scheme for 5G networks: Survey, security challenges, and channel analysis secrecy performance

Increasing Physical Layer Security through Hyperchaos in VLC Systems

On the Physical Layer Security of Visible Light Communications Empowered by Gold Nanoparticles

Multiple Optical Beam Switching for Physical Layer Security of Visible Light Communications

VLC Physical Layer Security through RIS-aided Jamming Receiver for 6G Wireless Networks

Practical MIMO for Visible Light Communication

Leveraging IRS Induced Time Delay for Enhanced Physical Layer Security in VLC Systems

VLC-Based Networking: Feasibility and Challenges

Enhancing secrecy rates in visible-light communications with signal-dependent noise: Exploring optical jamming technique

WoV: WiFi-based VLC testbed

Deep Reinforcement Learning-Enabled Secure Visible Light Communication Against Eavesdropping

Physical-Layer Security for Indoor VLC Wiretap Systems Under Multipath Reflections

Secrecy Performance Analysis for Water-to-Air Visible Light Communication

Secrecy Rate Bounds in Spatial Modulation-Based Visible Light Communications under Signal-Dependent Noise Conditions

VICO: A Framework for Configuring Indoor Visible Light Communication Networks