Abstract:LED lightings have made significant contributions to global energy saving, where one major challenge is the overheating of LED chips since the light output and lifespan of LED chips decrease exponentially with increasing operating temperature. Restricted by cooling capacity, the power input and light output of a LED bulb is limited. At present the luminous flux of commercial LED bulbs (A19 size) is usually limited to 800 lm with the related power consumption within 9 W. Therefore, there is an urgent market need for high-lumen bulbs while maintaining the size and shape as conventional incandescent bulbs. We report herein a novel design which could make full use of the entire outer surface of LED bulb as heat dissipating surface under passive cooling conditions. The novel design contains a chimney inside the bulb and an external heat sink, enabling two parallel heat dissipating paths, i.e., chips - heat sink - environment and chips - chimney - lampshade - environment. In conventional design with an external heat sink for cooling, the lampshade functions only to transmit light rather than dissipate heat. However, in the novel design the chimney inside the bulb could thermally activate the lampshade to dissipate heat as well. Upon properly distributing thermal loads to the two heat dissipating paths, cooling capacity of the novel bulb was optimized. With this design strategy, the passive cooling capacity was significantly improved to be 1.57 times higher than the conventional design and the commercially available bulbs of the same size and shape. Most importantly, the design strategy may be extended to other passive cooling scenarios such as indoor small cells for 5G communication.

Optimized aperiodic broadband thermal emitters for use as light bulb filaments

Toward High-Power-density Laser-Driven Lighting: Enhancing Heat Dissipation in Phosphor-in-glass Film by Introducing H-Bn.

Unusual Strategies For Using Indium Gallium Nitride Grown On Silicon (111) For Solid-State Lighting

The Effect of Different Filament Arrangements on Thermal and Optical Performances of LED Bulbs

A Facile Approach to Highly Efficient and Thermally Stable Solid-State Emitters: Knitting Up Aie-Active Tpe Luminogens by Aryl Linkers

Simultaneous Single-Peak and Narrowband Thermal Emission Enabled by Hybrid Metal-Polar Dielectric Structures

Low Voltage Energy-Saving Double-Walled Carbon Nanotube Electric Lamps

Nonperiodic Binary Optical Structures for Enhancing Light Extraction of Emitters

Design of a Novel LED Bulb with Entire Surface Thermally Activated for Passive Cooling

Fluorescent incandescent light sources from individual quadrilateral ZnO microwire via Ga-incorporation.

Tunable Narrowband Silicon-Based Thermal Emitter with Excellent High-Temperature Stability Fabricated by Lithography-Free Methods

Carbon Nanotube Filaments in Household Light Bulbs

Understanding and Modulating the Horizontal Orientations and Short‐range Charge Transfer Excited States for High‐performance Narrowband Emitters

A single Mn2+ ions activated fluosilicate glass with continuously tunable broadband emission from 475 nm to 800 nm

Optical and Electrical Properties of a Spiral LED Filament

Superior Thermally-Stable Narrow-Band Green Emitter from Mn2+-doped Zero Thermal Expansion (ZTE) Material

Broadband and Wide Angle Nonreciprocal Thermal Emission from Weyl Semimetal Structures

Integrated and spectrally selective thermal emitters enabled by layered metamaterials

Inverse Design of Refractory Mid-Wave Infrared Narrowband Thermal Emitters for Optical Gas Sensing

Strategic-tuning of Radiative Excitons for Efficient and Stable Fluorescent White Organic Light-Emitting Diodes.

Efficient and bright broadband electroluminescence based on environment-friendly metal halide nanoclusters