Abstract:Robustness of the natural rubber (NR) crystal at high temperatures is important because vehicle tires are easily subjected to high temperatures due to friction. To understand the robustness of crystals in the strained NR, as its plausible application to high temperatures, changes in the following structural parameters as a function of temperature were examined in this study by conducting two-dimensional wide-angle X-ray diffraction measurements: crystal lattice constants (a, b, c, and β), unit cell (volume, thermal expansivity, and orientation factor), degree of crystallinity, and crystallite (size, volume, and number density in the strained NR specimen). As a result for a vulcanized NR specimen subjected to a constant strain of 6, thermal shrinkage of the c-axis length was found in the heating process, while both a- and b-axis lengths were found to increase with an increase in the temperature. Furthermore, the volume of the crystal lattice was found to increase with the temperature, while the orientation degree of the crystal lattice remained unchanged. The degree of crystallinity was found to gradually decrease with temperature from the beginning of heating. As for the crystallite, the size along the stacking direction of the (200), (120), and (201) planes decreased with temperature, while that of the (002) plane (i.e., along the c-axis direction) was found to increase. These results indicate that crystallites grow in the NR main chain direction, while they are subjected to melting in the other perpendicular directions upon heating. However, it was found that the crystallite volume and the number density of crystallites in the strained NR specimen continuously decreased with the increasing temperature. The thermo-reversibility of all the structural parameters was also examined experimentally.

Temperature dependence of elastocaloric effect in natural rubber

A Lower Temperature Difference of The Elastocaloric Effect by Natural Rubber

Potential improvement for elastocaloric performances of shape memory alloys through comparing with natural rubber

Giant Reversible Barocaloric Effects in Nitrile Butadiene Rubber around Room Temperature

Elastocaloric Response of Isotropic Liquid Crystalline Elastomers

Large barocaloric effects at low pressures in natural rubber

Comprehensive Study on Temperature-Induced Crystallisation and Strain-Induced Crystallisation Behaviours of Natural Rubber/isoprene Rubber Blends

Application of a Strained Natural Rubber at High Temperatures

Enhancement of the Elastocaloric Performance of Natural Rubber by Forced Air Convection

Tunability of the elastocaloric response in main-chain liquid crystalline elastomers

Temperature Dependence of Elastocaloric Effect in a Microstructurally Graded NiTi Alloy

Room Temperature Elastocaloric Effect in Polycrystalline Ni51Mn34In8Sn7 Alloy

Tensile and Elastocaloric Properties of Natural/Devulcanized Waste Rubber Blends

Thermodynamically consistent non-isothermal phase-field modelling of elastocaloric effect: indirect vs direct method

Elastocaloric effect in amorphous polymer networks undergoing mechanotropic phase transitions

Anisotropy of elastocaloric cooling effect in equal atomic ratio NiTi alloy with crystallographic texture

Elastocaloric Effect in Ni50Fe19Ga27Co4 Single Crystals

Elastocaloric Effect Induced by the Rubber-Like Behavior of Nanocrystalline Wires of A Ti-50.8ni (at.%) Alloy

Grain-size Effects on the Temperature-Dependent Elastocaloric Cooling Performance of Polycrystalline NiTi Alloy

The Mechanism of ΔT Variation in Coupled Heat Transfer and Phase Transformation for Elastocaloric Materials and Its Application in Materials Characterization

Spontaneous thermal expansion of nematic elastomers