Single-ion quantum Otto engine with always-on bath interaction

Suman Chand,Asoka Biswas

DOI: https://doi.org/10.1209/0295-5075/118/60003

2017-05-03

Abstract:We demonstrate how a quantum Otto engine (QOE) can be implemented using a single ion and an always-on thermal environment. The internal degree of freedom of the ion is chosen as the working fluid, while the motional degree of freedom can be used as the cold bath. We show, that by adiabatically changing the local magnetic field, the work efficiency can be asymptotically made unity. We propose a projective measurement of the internal state of the ion that mimics the release of heat into the cold bath during the engine cycle. In our proposal, the coupling to the hot and the cold baths need not be switched off and on in an alternative fashion during the engine cycle, unlike other existing proposals of QOE. This renders the proposal experimentally feasible using the available tapped-ion engineering technology.

Quantum Physics

What problem does this paper attempt to address?

This paper attempts to address the problem of how to realize a quantum Otto engine (QOE) using a single ion, maintaining continuous interaction with the thermal bath throughout the entire thermal cycle, without the need to alternately switch the interaction with the thermal bath at different stages as in traditional methods. Specifically, the authors propose an experimentally feasible method to simulate the heat release process by changing the local magnetic field and performing projection measurements on the ion's electronic state, thereby achieving a highly efficient quantum engine.

### Main Problems and Solutions:

1. **Problem**: Traditional quantum engine schemes require alternately switching the interaction with the thermal bath at different stages, which is very challenging experimentally.
2. **Solution**:
- **Working Substance Selection**: Choose the internal degrees of freedom of a single ion as the working substance, while its vibrational degrees of freedom serve as the cold bath.
- **Continuous Interaction**: Maintain continuous interaction with the thermal bath throughout the entire thermal cycle, without the need for switching.
- **Magnetic Field Variation**: Achieve the adiabatic process by changing the local magnetic field, thereby improving working efficiency.
- **Projection Measurement**: Simulate the heat release process by performing projection measurements on the ion's electronic state, allowing the system to release heat from the cold bath.

### Implementation Method:

1. **Ignition Stroke**: The ion interacts with the thermal bath, reaching a thermal equilibrium state through Markovian evolution.
2. **Expansion Stroke**: Slowly change the local magnetic field, causing the system's energy levels to change without exchanging heat, thus achieving the adiabatic process.
3. **Exhaust Stroke**: Perform projection measurements on the ion's electronic state, allowing the system to release heat from the cold bath.
4. **Compression Stroke**: Slowly change the local magnetic field again, bringing the system back to its initial state, preparing for the next cycle.

### Main Conclusions:

- The above method can achieve nearly 100% working efficiency.
- This scheme is experimentally feasible based on existing ion trap technology, without the need for complex switching operations.
- Projection measurement not only simulates the heat release process but also improves efficiency by cooling the system.

### Significance:

This research provides a new approach for realizing highly efficient quantum engines, especially with high experimental feasibility, and is expected to promote further development in the field of quantum thermodynamics.