Abstract:Abstract The present investigation elucidates the interfacial characterization caused by the simultaneous effect of a symmetric converging rotational field and continuous air stream flow above the free surface. The converging rotational field is developed by a couple of counter and equal rotating rollers fully immersed inside the viscous liquid medium and their centers are aligned along a horizontal line. Such phenomenon is abundantly encountered in various engineering devices, where the interactions and transfer of mass, momentum, and energy are quite important through gas–liquid interfaces. Behavior of entrainment profile is observed due to the influence of various relevant pertinent parameters, namely, rotational of speed (measured by Ca), submersion depth (b*), the gap between the rollers (2a*), and strength of air stream flow (measured by Reflow). An upper rounded structured interfacial configuration is obtained for all cases of Ca when the rollers are located very close to each other. The length of the entrainment of cusp decreases with the rise of Reflow for the same value of Ca. The value of Cac increases continuously with the increase of Reflow for a particular of 2a* and b*. Bubble ejection from filament tip and subsequent accumulation increases significantly with the rise of Ca for a particular case of Reflow. The cusp tip progressively traverses in upward direction with the continuous increase of gravitational pull for a particular value of Ca and Reflow. Entrainment length progressively grows with the continuous rise of viscous drag for a particular value of Ca and Reflow. Finally, an analytical formulation is proposed to analyze the structure of entrainment and this model reports an excellent match with the numerical findings.

Air Entrainment by Viscous Contact Lines

Theory of Wetting-Induced Fluid Entrainment by Advancing Contact Lines on Dry Surfaces

Onset of Air Entrainment by a smooth plunging jet under atmospheric pressure

Bubble-Induced Entrainment at Viscoplastic-Newtonian Interfaces

Air entrainment during impact of droplets on liquid surfaces

Behavior of Gas Entrainment Inside Viscous Pool Due to Combined Influence of Symmetric Rotational Field and Freestream Flow of Air

Forced Dewetting In A Capillary Tube

Air entrainment by a plunging jet under intermittent vortex conditions

Universal mechanism for air entrainment during liquid impact

Air entrainment through free-surface cusps

Apparent Contact Angle and Contact Angle Hysteresis on Liquid Infused Surfaces

Viscous flow of a volatile liquid on an inclined heated surface

Deformation and dewetting of thin liquid films induced by moving gas jets

Dewetting films with inclined contact lines.

Spreading and engulfment of a viscoelastic film onto a Newtonian droplet

Failure mechanisms of air entrainment in drop impact on lubricated surfaces

Interaction of liquid films formed by two continuous jets impinging obliquely on a vertical wall

Developed liquid film passing a trailing edge: small-scale analysis and the `teapot effect' at large Reynolds numbers

Droplet dynamics under an impinging air jet

Vortices catapult droplets in atomization