Abstract:The carbon material prepared by co-pyrolysis of biochar and caking coal has been proved that it acts in catalytic conversion of volatiles and could be used in a granular bed duster as filter medium due to its high abrasive resistance in the coal pyrolysis technology. In this work, inactive carbon material loaded by nickel (Ni/ICM) was prepared by pyrolysis of the blend of biochar ion exchanged with nickel and caking coal, and then was steam activated obtaining activated carbon material loaded by nickel (Ni/ACM). The study investigated the in-situ catalytic conversion process of coal pyrolysis volatiles over Ni/ICM and Ni/ACM in a continuous pyrolysis downer-bed reactor. The physical and chemical properties of Ni/ICM and Ni/ACM, pyrolysis product distribution and the component of tar were analyzed, especially, the coke suspended in tar (Coke-S) was separated from tar and characterized in detail. Results show that the crystallite size of Ni and NiO in Ni/ICM is about 5-7 nm, and that is slightly larger in Ni/ACM. Compared to Ni/ICM, more nickel species, pores, acid sites, oxygen-containing functional groups and carbon defects are contained in Ni/ACM. The yields of tar and light tar (boiling point below 360 o C) are higher over Ni/ICM than over Ni/ACM. Ni/ICM further improves the tar quality compared to ICM, and the content of light oil in tar increases from 22.0 wt.% over ICM to 30.6 wt.% over Ni 3.2 /ICM. The highest light oil yield is obtained over Ni 1.9 /ICM as 3.6 wt.% and the lowest pitch yield is obtained over Ni 3.2 /ICM as 3.5 wt.%. The characterization of Coke-S shows that it is composed of large aromatic clusters crosslinked by oxygen and fine ash particles. The large aromatic clusters, as heavy component in tar, are found that its H/C molar ratio increases and condensation degree decreases over Ni/ICM and Ni/ACM in comparison with ICM and ACM, respectively, which also means that the quality of tar is improved. Besides, the oxygen in the tar may have been transferred to the coke.

Low-temperature graphitization of carbon foam using nickel-based catalysts for enhanced thermal conductivity: application in the pyrolysis of oil-rich coal

Raman analysis of lignin conductive char

In situ Ti assisted graphitization approach for the preparation of graphite foam with light weight and high thermal conductivity

Fe–Co based synergistic catalytic graphitization of biomass: Influence of the catalyst type and the pyrolytic temperature

Preparation of Graphene-Like Porous Carbons With Enhanced Thermal Conductivities From Lignin Nano-particles by Combining Hydrothermal Carbonization and Pyrolysis

Catalytic Influence of Iron Oxide (fe2o3) on Coal Pyrolysis and Char Combustion at Various Temperatures

Carbon Aerogel with High Thermal Conductivity Enabled by Shrinkage Control

Preparation of Carbon Materials by Vapor Deposition with Fe 3+ -Modified Nickel Foam from Biomass Pyrolysis Gas

Study of Micro-Structure Based Effective Thermal Conductivity of Graphite Foam

Coal Tar Pitch Based Carbon Foam for Thermal Insulating Material

Nickel Loaded on Carbon Materials Prepared From Co-pyrolysis of Biochar and Caking Coal for Catalytic Conversion of Volatiles

Effects of coal characteristics on the structure and performance of coal-based carbon foam prepared by self-foaming technique under atmospheric pressure

Observation of carbon nanostructure and evolution of chemical structure from coal to graphite by high temperature treatment, using componential determination, X-ray diffraction and high-resolution transmission electron microscope

Carbon Foams Prepared from Coal Tar Pitch for Building Thermal Insulation Material with Low Cost

Enhancing oil shale pyrolysis using metal-doped carbon quantum dot catalysts: A comprehensive behavioral, kinetic, and mechanistic analysis

Effect of high-temperature pyrolysis on the structure and properties of coal and petroleum coke

Experimental Study on the Effect of Temperature and Oxygen on Pyrolysis-Gasification Decoupling Characteristics of Yili Coal

Effects of Iron Minerals Embedded in Coal with Different Methods on the Distribution of Pyrolysis Products and the Gasification Reactivity of Its Pyrolysis Char

Metal-foam-structured Ni–Al2O3 Catalysts: Wet Chemical Etching Preparation and Syngas Methanation Performance

Tuning the Properties of Iron-Doped Porous Graphitic Carbon Synthesized by Hydrothermal Carbonization of Cellulose and Subsequent Pyrolysis

The Effect of B4C on the Properties of Graphite Foam Prepared by Template Method