Abstract:The effective solution to avoid machinery damage caused by resonance has been perplexing the field of engineering as a core research direction since the resonance phenomenon was discovered by Euler in 1750. Numerous attempts have been performed to reduce the influence of resonance since the earlier of last century, by introducing a nonlinear structure or a closed-loop control system. However, the existed methodologies cannot eliminate resonance completely even extra problems were introduced inevitably, which means the technical choke-point of resonance-free remains unsolved. Here we propose a designable archetype model, which establishes a mapping between the mechanical properties and its structure. A general inverse method for structure construction is proposed based upon the required property for the system with quasi-zero stiffness of any designed finite order and the zero-stiffness properties. It is shown that an ellipse trajectory tracking of the designed model is the sufficient and necessary condition to satisfy the zero-stiffness property. Theoretical analysis shows that no resonant response happens in a zero-stiffness system to the full-band frequency excitation, or equivalently, the system can completely isolate the energy transfer between the load and environment, when the damping ratio approaches zero. Finally, an experimental rig for the prototype structure is built up according to the sufficient and necessary condition of the zero-stiffness system, for which the special dynamic behaviours are verified through experiments of frequency-sweep and random-vibration as well. Experimental results show that the prototype of the initial vibration isolation frequency of zero-stiffness system is much lower than 0.37 Hz, and the vibration attenuation of the proposed model is about 16.86 dB, 45.63 dB, and 112.37 dB at frequencies of 0.37 Hz, 1 Hz, and 10 Hz, respectively. The distinguished geometric structure of the zero-stiffness system leads to a new inspiration for the design of resonance-free in metamaterial unit and the inverse method can even adapt the design for a more targeted applications based on an arbitrary complex dynamic requirement.

Geometry-Invariant Resonant Cavities

An Anisotropic Metamaterial-Based Rectangular Resonant Cavity

Inverse Design of Discrete Mechanical Metamaterials

Concept for a geometry-insensitive high-field magnetic resonance detector

Quasi-Babinet principle in dielectric resonators and Mie voids

Transverse Magnetic ENZ Resonators: Robustness and Optimal Shape Design

Selective Passive Tuning of Cavity Resonance by Mode Index Engineering of the Partial Length of a Cavity

Design of resonators using materials with negative refractive index

Zero refractive index in space-time acoustic metamaterials

Characterization of Microresonator-Geometry-deformation for Cavity Optomechanics.

Inerter-based elastic metamaterials for band gap at extremely low frequency

Analysis of Eigenmodes for Asymmetric Resonant Micro-Cavities

Cavity Continuum

Geometry-independent antenna based on Epsilon-near-zero medium

Indefinite metacavities coupled to a mirror: bound states in the continuum with anomalous resonance scaling

Nesting and Degeneracy of Mie Resonances of Dielectric Cavities Within Zero-Index Materials

Acoustic Bound States in the Continuum in Coupled Helmholtz Resonators

Topological Supercavity Resonances in the Finite System

High-quality-factor planar optical cavities with laterally stopped, slowed, or reversed light

Electromagnetically-induced-transparency–like Phenomenon with Resonant Meta-Atoms in a Cavity

Road to entire insulation for resonances from a forced mechanical system